Valve Mechanism Cover - Remove and Install - C27
Show/hide table
PERHATIAN |
---|
Pastikan semua suku cadang bersih dari kontaminan. Kontaminan dapat menyebabkan keausan yang cepat dan mempersingkat umur komponen. |
- Lepaskan baut (1) dan penutup mekanisme katup (2).
Show/hide table
Ilustrasi 1 | g01265909 |
Show/hide table
PERHATIAN |
---|
Pastikan semua suku cadang bersih dari kontaminan. Kontaminan dapat menyebabkan keausan yang cepat dan mempersingkat umur komponen. |
- Pasang seal (3) pada penutup mekanisme katup (2).
Show/hide table
Ilustrasi 4 g01265909 Show/hide tableIlustrasi 5 g03225827 - Letakkan penutup mekanisme katup (2) di dudukan penutup mekanisme katup. Pasang baut (1). Kencangkan baut (1) dengan urutan seperti yang ditunjukkan pada gambar 5.
Show/hide table
Ilustrasi 2 | g06078165 |
Show/hide table
Ilustrasi 3 | g06078161 |
Catatan: Pastikan seal dipasang dengan benar pada penutup mekanisme katup. Bagian sempit pada seal harus menghadap keluar, menjauh dari penutup mekanisme katup.
Caterpillar Information System:
C7 On-Highway Engine Inlet Air Temperature Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Fuel Filter Base - Install - C27
C7 On-Highway Engine Atmospheric Pressure Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Fuel Filter Base - Remove - C27
C7 On-Highway Engine Turbocharger Outlet Temperature Sensor - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module Engine Speed/Timing Sensor
C7 On-Highway Engine Flame Detection Temperature Sensor - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module Ether Injection System
C11, C13, and C15 On-highway Engines Fuel System Primary Filter - Replace
C7 On-Highway Engine Clean Gas Induction Valve - Disassemble
770, 772, 773E, 773F, 777E and 777F Off-Highway Trucks and 775F Quarry Truck VIMS Truck Payload System Electronic Control Module (ECM) - Configure
3500B Industrial Engines with the ADEM 3 Electronic Control Module Emergency Stop Switch
C27 and C32 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install - C27
C27 and C32 Engines for Caterpillar Built Machines Cylinder Head - Remove - C27
C9 On-highway Engine Gear Group (Rear)
C27 and C32 Engines for Caterpillar Built Machines Cylinder Head - Install - C27
C175-16 and C175-20 Generator Set Engines Valve Mechanism
BA-921 Bendix Air Compressor Air Compressor is Noisy
C7 On-Highway Engine Solenoid Valve (ARD Main Fuel) - Remove and Install
C13 Engine Boost Pressure Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Camshaft - Install - C27
2006/08/07 A New Oil Pump for the Hydrax System is Used {1716, 5073}
C7 On-Highway Engine Air Inlet Cover - Remove and Install
C9 Marine Engines and C9 Marine Generator Sets Injection Actuation Pressure Sensor