Fuel Transfer Pump - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install fuel transfer pump (9). Install bolt (8) and stud (7).
Show/hide table
Illustration 2 g01265657 - Install bolt (6) and stud (5).
Show/hide table
Illustration 3 g01265656 - Install bracket (4). Install nut (3).
Show/hide table
Illustration 4 g01265654 - Install nut (2). Install bolt (1).
Show/hide table
Illustration 1 | g01265658 |
Note: Check the O-ring seals for proper orientation prior to installation.
End By:
- Install the fuel manifold. Refer to Disassembly and Assembly, "Fuel Control Manifold (ARD) - Install".
Caterpillar Information System:
3412E and C30 Marine Engines Cooling System Coolant (ELC) - Change
C13 Engine Accessory Drive - Disassemble
3412E and C30 Marine Engines Cooling System Coolant (DEAC) - Change
G3304 and G3306 Engines Coolant Level Sensor
C7 On-Highway Engine Fuel Transfer Pump - Remove
TA19-M2WD and TA19-M4WD Agricultural Transmissions Relief Valve (Transmission Main) - Install
TA19-M2WD and TA19-M4WD Agricultural Transmissions Relief Valve (Transmission Main) - Remove
3500B Industrial Engines with the ADEM 3 Electronic Control Module Electrical Power Supply
3044C Industrial Engine Plate Locations and Film Locations
TA19-M2WD and TA19-M4WD Agricultural Transmissions Modulating Valve (Transmission Clutch) - Remove and Install
C7 On-Highway Engine Flywheel - Install
770 and 772 Off-Highway Trucks Automatic Lubrication System Visual Inspection
C13 Engine Accessory Drive - Assemble
C27 and C32 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
TA19-M2WD and TA19-M4WD Agricultural Transmissions Pump Drive - Remove
C9 On-highway Engine Fuel Control Manifold (ARD) - Disassemble
C9 On-highway Engine Fuel Control Manifold (ARD) - Assemble
3500B Industrial Engines with the ADEM 3 Electronic Control Module Emergency Stop Switch
770, 772, 773E, 773F, 777E and 777F Off-Highway Trucks and 775F Quarry Truck VIMS Truck Payload System Electronic Control Module (ECM) - Configure
C7 On-Highway Engine Clean Gas Induction Valve - Disassemble
C11, C13, and C15 On-highway Engines Fuel System Primary Filter - Replace
3500B Industrial Engines with the ADEM 3 Electronic Control Module Ether Injection System
C7 On-Highway Engine Flame Detection Temperature Sensor - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module Engine Speed/Timing Sensor