C4.4 Industrial Engine Caterpillar

Starter Motor

Usage:

C4.4 444

24 Volt Starting Motor 4.5 Kw

Show/hide table




Illustration 1	g01200801
Typical example

(1) Tighten the negative terminal nut to the following torque. ... 15 N·m (11 lb ft)

(2) Tighten the positive terminal nut to the following torque. ... 21 N·m (15 lb ft)

(3) Tighten the solenoid terminal to the following torque. ... 3.5 N·m (31 lb in)

Rated voltage ... 24 volts

12 Volt Starting Motor 3 Kw

Show/hide table




Illustration 2	g01335925
Typical example

(1) Tighten the nut for the positive terminal (terminal 30) to the following torque. ... 6 N·m (53 lb in )

(2) Tighten the solenoid terminal (terminal 50) to the following torque. ... 8 N·m ( 70 lb in)

(3) Tighten the nut for the terminal for the earth to the following torque. ... 8 N·m ( 70 lb in)

Rated voltage ... 12 volts

Pull in voltage ... 8 volts

Caterpillar Information System:

C4.4 Industrial Engine Alternator

C4.4 (Mech) Industrial Engine Crankshaft Seals

C4.4 Industrial Engine Engine Oil and Filter - Change

C15 Industrial Engine Poor Acceleration or Response

C15 Industrial Engine Low Power/Poor or No Response to Throttle

C3.3 and C4.4 Generator Sets Engine Oil Pan - Remove and Install

C9 Industrial Engines Piston and Rings

2006/10/23 An Improved Turbocharger is Used {1052, 1053}

C15 Petroleum Generator Set Engines Cylinder Block

C3.3 and C4.4 Generator Sets Camshaft - Remove and Install

C27 and C32 Engines for Caterpillar Built Machines Piston and Rings - C32 Engines

G3508, G3512 and G3516 Engines Engine Oil Cooler - Install

C3.3 and C4.4 Generator Sets Engine Oil Filter Base - Remove and Install

C3.3 and C4.4 Generator Sets Speed/Timing Sensor - Remove and Install

C3.3 and C4.4 Generator Sets Electric Starting Motor - Remove and Install

C7 Urban Transit Bus Engines Maintenance Interval Schedule

C4.4 Industrial Engine Gear Group (Front)

C3.3 and C4.4 Generator Sets Engine Enclosure Group - Remove and Install

C4.4 Industrial Engine Exhaust Manifold

C9 Industrial Engines Front Housing and Covers

C4.4 Industrial Engine Connecting Rod Bearing Journal - Steel Crankshaft

C4.4 Industrial Engine Rocker Shaft

TH31-C9I, TH31-C9P, TH31-C9T, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Transmission Hydraulic Oil Contamination - Test

CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 126 - FMI 3