Speed/Timing Sensor - Remove and Install
Show/hide table
When servicing or repairing electric power generation equipment: Make sure the unit is off-line (disconnected from utility and/or other generators power service), and either locked out or tagged DO NOT OPERATE. Remove all fuses. |
- Disconnect harness assembly (3) from speed/timing sensor (2).
- Loosen locknut (1).
- Remove speed/timing sensor (2) from the flywheel housing.
Show/hide table
Illustration 1 | g01253814 |
- Install speed/timing sensor (2) into the flywheel housing until contact is made with the flywheel. Back out speed/timing sensor (2) by approximately one half turn.
- Tighten locknut (1).
- Connect harness assembly (3).
Show/hide table
Illustration 2 | g01253814 |
Caterpillar Information System:
C3.3 and C4.4 Generator Sets Engine Oil Filter Base - Remove and Install
C4.4 Industrial Engine Starter Motor
C4.4 Industrial Engine Alternator
C4.4 (Mech) Industrial Engine Crankshaft Seals
C4.4 Industrial Engine Engine Oil and Filter - Change
C15 Industrial Engine Poor Acceleration or Response
C15 Industrial Engine Low Power/Poor or No Response to Throttle
C3.3 and C4.4 Generator Sets Engine Oil Pan - Remove and Install
C9 Industrial Engines Piston and Rings
2006/10/23 An Improved Turbocharger is Used {1052, 1053}
C15 Petroleum Generator Set Engines Cylinder Block
C3.3 and C4.4 Generator Sets Camshaft - Remove and Install
C3.3 and C4.4 Generator Sets Electric Starting Motor - Remove and Install
C7 Urban Transit Bus Engines Maintenance Interval Schedule
C4.4 Industrial Engine Gear Group (Front)
C3.3 and C4.4 Generator Sets Engine Enclosure Group - Remove and Install
C4.4 Industrial Engine Exhaust Manifold
C9 Industrial Engines Front Housing and Covers
C4.4 Industrial Engine Connecting Rod Bearing Journal - Steel Crankshaft
C4.4 Industrial Engine Rocker Shaft
TH31-C9I, TH31-C9P, TH31-C9T, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Transmission Hydraulic Oil Contamination - Test
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 126 - FMI 3
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 126 - FMI 16
C280 Marine Propulsion Engines Aftercooler Coolant Pressure Low