1984/12/10 Caterpillar


New Pressure Gauges Have Dual Scales [kPa (psi)]{0600}

Usage:


All Caterpillar Products

SUPPLEMENT: 05/06/85

SERVICE MAGAZINE, DECEMBER 10, 1984, PAGE 2. In the article, "New Pressure Gauges Have Dual Scales [kPa (psi)]", put a mark through the last paragraph. The correct last paragraph follows:

Dealers can have 2 1/2" gauges recalibrated for a fee of $8.50 plus shipping. Dealers can have 2 1/2" single scale gauges (kPa only) recalibrated and converted to dual scale gauges for $11.00 plus shipping. Send a purchase order to Carrier-Oehler along with the gauge. Conversions can be done when gauges are sent in for repair or calibration.

--------------- END SUPPLEMENT ---------------

New dual scale, fluid filled pressure gauges are available. The outside scale of the dial face is pounds per square inch (psi). The inside scale is kilopascals (kPa). A yellow band on the dial face identifies the kPa scale. The gauges are 63.5 mm (2.50") diameter and the case is made of brass. The gauges have ASA Grade A accuracy. All gauges have 1/4-18 NPTF connections. The chart gives the part numbers for the new dual scale gauges.

Repair Information

Repair is available in the United States from:

Carrier-Oehler Company
1695 Vincennes Avenue
P.O. Box 40
South Holland, Illinois 60473

Repair services are available worldwide through Wika offices.

Dealers can convert single scale gauges (kPa only) to dual scale gauges for a fee of $8.50 plus shipping. Send a purchase order to Carrier-Oehler along with the gauge. Conversion can be done at any time or when gauges are sent in for repair or calibration.

Caterpillar Information System:

1984/12/10 Fill Oil Sump Before Installing Woodward Governor{1264,1288,1289}
1984/11/26 New Fuel Injector Assembly Reduces Smoke When Operating At Lower RPM And Load{1251,1250}
1984/11/26 Identification Of Camshaft Groups And Valve Mechanism Groups{1210,1102}
1984/11/26 Important Differences In Engine Arrangements On 3208 Engines Equipped With Turbochargers{1000}
1984/11/26 Rear Power Take-Off Clutch Can Use Nonmetallic Plates And Grease Lubrication For Main Bearings{3055,3305}
1984/11/26 Causes And Correction Of Opposite Crankshaft Rotation In Direct Injection Engines{1000}
1984/11/19 Remanufactured Piece Parts Now Available For Turbochargers (U.S. and Canada Only){1052,1053,1056,1065,1077}
1984/11/19 Fuel Setting And Related Information Microfiche Corrected, Improved{0374,0375}
1984/11/19 Additional Information For Correct Fuel Injector Timing{1290}
1984/11/19 Remanufactured Cylinder Head Groups{1100,1101,7554}
1984/11/19 Use Care When Installing Circuit Boards In Regulators{4467}
1984/11/05 Thread Identification Kit Available{0600,0760}
1984/12/10 Lubrication Decals (Films) Are No Longer Used On Machines{7557}
1984/12/10 Starters That Remain Engaged After Engine Is Running{1453}
1984/12/10 New 76.6°C (170°F) Water Temperature Regulators Used In Inlet Controlled Cooling Systems{1355,1350}
1984/12/10 New Air Pipe Retainers Used To Connect Turbocharger To Aftercooler{1052,1063}
1984/12/10 Improved BrakeSaver Seals Available{1155}
1984/12/10 A Soot Filter Is Available For Use With Air Cleaners{1054}
1984/12/10 New Seal Used In Alternator Mounting Group{1405,1400}
1984/12/10 Addition Of Lubricator Will Help Prevent Corrosion In Air Prelube Motors{1319}
1984/12/10 Improved Turbocharger Oil Drain Elbows{1307,1052}
1984/12/10 Additional Clamp Reduces Vibration Of Turbocharger Oil Supply Line{1050,1052,1053}
1984/12/10 Bonnet Of Fuel Injection Pump Group Now Serviced Separately{1251,1250}
1985/01/14 Minimize Fuel Problems In Cold Weather Operation {1280,1250}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.