Thread Identification Kit Available{0600,0760}
Usage:
The 8T450 Thread Identification Kit is available to help determine thread sizes. The size of internal port threads, external adapter threads and bolt threads can be measured with the tools in the kit.
Components of the 8T450 Thread Identification Kit are the 8T447 Dial Caliper, 8T448 Pitch Gauge, 8T449 Seat Angle Gauge, 8T451 Seat Angle Gauge, case and Special Instruction Form SEHS8429.
8T450 Thread Identification Kit.
Caterpillar Information System:
1984/11/05 Preferred Engine Timing Procedures{1250,1286,1290,1292}
1984/11/05 Remove Diode Assemblies From Shutoff Solenoids{1259}
1984/10/29 New Outer Bearing Race Used In Auxiliary Fan Drive Group{1390}
1984/10/29 New Diaphragm Used In BrakeSaver Control Valve Group{1159,1155}
1984/10/29 New Cylinder Heads, Fuel Nozzles And Fuel Nozzle Adapters Used{1101,1106}
1984/10/29 New Heat Shield For Wiring To Electrical Shutoff Group{7400,7403,7418}
1984/10/29 New Cylinder Head Gasket Helps Prevent Oil Leakage Around Gear Pocket{1101}
1984/10/29 New Oil Filter Group Can Be Used To Extend Oil Change Interval{1306,1318,1326}
1984/10/29 Foil Shield Will Help Prevent Electrical Interference In Engine Set Point Indicator{0781,0785}
1984/10/29 Cetane Injection Group Uses New Orifice, Tee and Seals{1250,1274}
1984/10/22 Information For Testing 8N7004, 4W7011 And 4W7015 Fuel Injection Nozzles{1254}
1984/10/22 Changes To Water Lines Group Increase Coolant Flow Through Exhaust Manifold{1059}
1984/11/19 Use Care When Installing Circuit Boards In Regulators{4467}
1984/11/19 Remanufactured Cylinder Head Groups{1100,1101,7554}
1984/11/19 Additional Information For Correct Fuel Injector Timing{1290}
1984/11/19 Fuel Setting And Related Information Microfiche Corrected, Improved{0374,0375}
1984/11/19 Remanufactured Piece Parts Now Available For Turbochargers (U.S. and Canada Only){1052,1053,1056,1065,1077}
1984/11/26 Causes And Correction Of Opposite Crankshaft Rotation In Direct Injection Engines{1000}
1984/11/26 Rear Power Take-Off Clutch Can Use Nonmetallic Plates And Grease Lubrication For Main Bearings{3055,3305}
1984/11/26 Important Differences In Engine Arrangements On 3208 Engines Equipped With Turbochargers{1000}
1984/11/26 Identification Of Camshaft Groups And Valve Mechanism Groups{1210,1102}
1984/11/26 New Fuel Injector Assembly Reduces Smoke When Operating At Lower RPM And Load{1251,1250}
1984/12/10 Fill Oil Sump Before Installing Woodward Governor{1264,1288,1289}
1984/12/10 New Pressure Gauges Have Dual Scales [kPa (psi)]{0600}