Turbocharger - Remove
Removal Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
- Disconnect hose assembly (1) and hose (2) .
Show/hide table
 | |
| Illustration 1 | g01175826 |
- Remove tube assembly (3) and the gasket.
Show/hide table
 | |
| Illustration 2 | g01175760 |
- Disconnect tube assembly (6) and remove the gasket.
- Remove nuts (5), turbocharger (4), and the gasket.
Caterpillar Information System:
C-10 Petroleum Engine Electronic Unit Injector Sleeve - Install
C9 Engine for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor - Remove and Install
XQ60 Rental Generator Set Product Lifting
345C MHPU Mobile Hydraulic Power Unit Machine Systems Piston Motor (Hydraulic Fan) - Assemble
345C MHPU Mobile Hydraulic Power Unit Machine Systems Piston Motor (Hydraulic Fan) - Disassemble
C9 Engine for Caterpillar Built Machines Speed/Timing Sensor - Remove and Install
325D and 329D Excavators Hydraulic System Solenoid Valve (Hydraulic Lockout)
C9 Engine for Caterpillar Built Machines Injection Actuation Pressure Sensor - Remove and Install
C7 PETROLEUM Petroleum Engine Fuel Pressure Sensor - Remove and Install
C32 Power Module Engine Air Cleaner Element (Dual Element) - Clean/Replace - If Equipped
C9 Engine for Caterpillar Built Machines Engine Oil Pressure Sensor - Remove and Install
3500 Industrial and Generator Set Engines Air Shutoff - Test
C-10 Petroleum Engine Turbocharger - Disassemble
C-10 Petroleum Engine Turbocharger - Assemble
C9 Engine for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install
C-10 Petroleum Engine Turbocharger - Install
C-10 Petroleum Engine Exhaust Manifold - Remove and Install
C9 Engine for Caterpillar Built Machines Fan Drive - Remove
C9 Engine for Caterpillar Built Machines Fan Drive - Disassemble
2005/06/27 Improved Engine Oil Coolers are Now Used {1378}
2005/07/11 Improved Engine Oil Coolers are Now Used {1378}
C-10 Petroleum Engine Inlet Manifold - Remove
2005/07/01 Improved Engine Oil Coolers are Now Used {1378}
3500 Locomotive Engines Air Shutoff