Electronic Unit Injector Sleeve - Install
Installation Procedure
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| B | 4C-5552 | Large Bore Brush | 1 |
| C | 9U-7237 | Brush Extension | 1 |
| 9U-7244 | End Brush | 1 | |
| D | 9U-7258 | Driver Cap | 1 |
| E | 4C-9507 | Retaining Compound | 1 |
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tooling (B) in order to clean the unit injector bore.
Show/hide table
 | |
| Illustration 1 | g01020899 |
- Use Tooling (C) in order to clean the unit injector seat.
Note: Check the fuel passage in the cylinder head assembly. Remove any debris left from the use of Tooling (B) and Tooling (C) .
- Apply Tooling (E) to upper land (2) and lower land (3) on the unit injector sleeve.
- Position unit injector sleeve (1) in the cylinder head assembly. Use Tooling (D) and a hammer in order to seat the unit injector sleeve.
Show/hide table
 | |
| Illustration 2 | g01076889 |
- Refill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
End By: Install the electronic unit injectors. Refer to Disassembly and Assembly, "Electronic Unit Injector - Install".
Caterpillar Information System:
C9 Engine for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor - Remove and Install
XQ60 Rental Generator Set Product Lifting
345C MHPU Mobile Hydraulic Power Unit Machine Systems Piston Motor (Hydraulic Fan) - Assemble
345C MHPU Mobile Hydraulic Power Unit Machine Systems Piston Motor (Hydraulic Fan) - Disassemble
C9 Engine for Caterpillar Built Machines Speed/Timing Sensor - Remove and Install
325D and 329D Excavators Hydraulic System Solenoid Valve (Hydraulic Lockout)
C9 Engine for Caterpillar Built Machines Injection Actuation Pressure Sensor - Remove and Install
C7 PETROLEUM Petroleum Engine Fuel Pressure Sensor - Remove and Install
C32 Power Module Engine Air Cleaner Element (Dual Element) - Clean/Replace - If Equipped
C9 Engine for Caterpillar Built Machines Engine Oil Pressure Sensor - Remove and Install
3500 Industrial and Generator Set Engines Air Shutoff - Test
C9 Engine for Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
C-10 Petroleum Engine Turbocharger - Remove
C-10 Petroleum Engine Turbocharger - Disassemble
C-10 Petroleum Engine Turbocharger - Assemble
C9 Engine for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install
C-10 Petroleum Engine Turbocharger - Install
C-10 Petroleum Engine Exhaust Manifold - Remove and Install
C9 Engine for Caterpillar Built Machines Fan Drive - Remove
C9 Engine for Caterpillar Built Machines Fan Drive - Disassemble
2005/06/27 Improved Engine Oil Coolers are Now Used {1378}
2005/07/11 Improved Engine Oil Coolers are Now Used {1378}
C-10 Petroleum Engine Inlet Manifold - Remove
2005/07/01 Improved Engine Oil Coolers are Now Used {1378}