Turbocharger - Disassemble
Disassembly Procedure
Start By:
- Remove the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 1 | g01175781 |
- Position the turbocharger on a bench.
- Place alignment marks on compressor housing (1), turbocharger cartridge (4), and turbine housing (3) .
- Remove bolts (2) from compressor housing (1) .
- Remove compressor housing (1) from turbocharger cartridge (4) .
- Remove bolts (5) from turbine housing (3) .
- Remove turbine housing (3) from turbocharger cartridge (4) .
- Check the condition of all the components. Use new components to replace worn components or damaged components.
Show/hide table
NOTICE |
---|
Do not attempt to disassemble the turbocharger cartridge assembly or wastegate. Do not remove the compressor wheel. The turbocharger cartridge assembly and the wastegate are not field serviced, and should be replaced only as a unit. |
Caterpillar Information System:
C-10 Petroleum Engine Turbocharger - Remove
C-10 Petroleum Engine Electronic Unit Injector Sleeve - Install
C9 Engine for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor - Remove and Install
XQ60 Rental Generator Set Product Lifting
345C MHPU Mobile Hydraulic Power Unit Machine Systems Piston Motor (Hydraulic Fan) - Assemble
345C MHPU Mobile Hydraulic Power Unit Machine Systems Piston Motor (Hydraulic Fan) - Disassemble
C9 Engine for Caterpillar Built Machines Speed/Timing Sensor - Remove and Install
325D and 329D Excavators Hydraulic System Solenoid Valve (Hydraulic Lockout)
C9 Engine for Caterpillar Built Machines Injection Actuation Pressure Sensor - Remove and Install
C7 PETROLEUM Petroleum Engine Fuel Pressure Sensor - Remove and Install
C32 Power Module Engine Air Cleaner Element (Dual Element) - Clean/Replace - If Equipped
C9 Engine for Caterpillar Built Machines Engine Oil Pressure Sensor - Remove and Install
C-10 Petroleum Engine Turbocharger - Assemble
C9 Engine for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install
C-10 Petroleum Engine Turbocharger - Install
C-10 Petroleum Engine Exhaust Manifold - Remove and Install
C9 Engine for Caterpillar Built Machines Fan Drive - Remove
C9 Engine for Caterpillar Built Machines Fan Drive - Disassemble
2005/06/27 Improved Engine Oil Coolers are Now Used {1378}
2005/07/11 Improved Engine Oil Coolers are Now Used {1378}
C-10 Petroleum Engine Inlet Manifold - Remove
2005/07/01 Improved Engine Oil Coolers are Now Used {1378}
3500 Locomotive Engines Air Shutoff
C15 and C18 Petroleum Generator Sets Engine Oil and Filter - Change