Valve Rocker Arm
Show/hide table
Illustration 1 | g01398538 |
(1) Inlet rocker arm |
(A) Bore for the rocker shaft ...
Show/hide table
Illustration 2 | g01398539 |
(2) Exhaust rocker arm |
(B) Bore for the rocker shaft ...
Caterpillar Information System:
3406E Marine Engine Engine Support (Front) - Remove and Install
PL1000E Communication ECM General Information
3500 Generator Sets Electrical System
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Assemble
G3500 Engines Air Starting Motor - Assemble
C13 and C15 On-highway Engines Coolant Level - Test
C7 and C9 On-Highway Engines Air Inlet Heater - Test
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Disassemble
C7 On-highway Engine Fuel Filter Base
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Install
3500 Industrial and Generator Set Engines Sea Water Strainer - Clean/Inspect - if equipped
C9.3 Engines for Caterpillar Built Machines Lubrication System
C9 Engine for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
C13 and C15 On-highway Engines Injector Trim File - Install
C4.4 Industrial Engine Engine Valve Lash - Inspect/Adjust
C4.4 Industrial Engine Fuel Tank Water and Sediment - Drain
C4.4 (Mech) Industrial Engine Starting Motor - Inspect
C9 Engine for Caterpillar Built Machines Flywheel - Remove and Install
C7 On-highway Engine Fuel System - Prime
C7 On-highway Engine Fuel System Pressure - Test
PL1000E Communication ECM Features
C9 Engine for Caterpillar Built Machines Crankshaft Front Seal - Remove
C27 and C32 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
PL1000E Communication ECM Electronic Control Module (ECM)