Engine Oil Pump - Install
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
A | 1P-0510 | 冲头总成 | 1 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将轴 (9) 安装到发动机机油泵 (1) 上。 使用工具 (A) 和适当的压具将轴承 (10) 安装到惰齿轮 (11) 中。 将惰齿轮 (11) 安装到轴 (9) 上。 安装螺栓 (12) 和垫圈。
Show/hide table
图 2 g01172397 - 放置好机油吸油管 (6) 和密封垫。 安装螺栓 (5)。 放置好出口弯头 (8) ,并安装螺栓 (7)。
注: 确保彻底清洁发动机机油泵的安装面。
- 检查 O 形密封圈的状况。 必要时,应更换 O 形密封圈。
Show/hide table
图 3 g01172390 - 安装位于缸体与排气弯头之间的 O 形密封圈。 将发动机机油泵 (1) 在缸体上放置好。
- 安装螺栓 (2)。
- 安装螺栓 (3)。
- 安装螺栓 (4)。
Show/hide table
图 1 | g01172401 |
结束:
- 安装发动机油底壳。 请参阅拆解和组装, "发动机油底壳 - 拆卸和安装"。
Caterpillar Information System:
3500 Industrial and Generator Set Engines Sea Water Strainer - Clean/Inspect - if equipped
C9.3 Engines for Caterpillar Built Machines Lubrication System
3500 Industrial and Generator Set Engines Auxiliary Water Pump - Inspect - if equipped
3500 and 3500B Engines Heat Exchanger - Inspect - if equipped
C13 and C15 On-highway Engines Air Shutoff - Test
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Remove
C18 Marine Generator Set Engines Sensors and Electrical Connectors
C9 Marine Auxiliary and Marine Generator Set Engines Coolant Temperature Is Too High
C27 and C32 Industrial and Petroleum Engines System Configuration Parameters
C13 and C15 On-highway Engines Sensor Signal (PWM) - Test
2005/06/06 Prevent Spontaneous Engine Shutdown {1000}
2005/06/06 New Inlet Manifold Pressure Sensors are Available {1058, 1923}
C7 On-highway Engine Fuel Filter Base
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Disassemble
C7 and C9 On-Highway Engines Air Inlet Heater - Test
C13 and C15 On-highway Engines Coolant Level - Test
G3500 Engines Air Starting Motor - Assemble
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Assemble
3500 Generator Sets Electrical System
PL1000E Communication ECM General Information
3406E Marine Engine Engine Support (Front) - Remove and Install
C11 and C13 Engines Valve Rocker Arm
C9 Engine for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
C13 and C15 On-highway Engines Injector Trim File - Install