Sea Water Strainer - Clean/Inspect - if equipped
海水過濾器必須保持乾淨,才能讓引擎適當冷卻。 檢查海水過濾器是否阻塞。 更頻繁地檢查處於淺水或髒水情況下的海水過濾器。 請參閱 OEM 建議以瞭解關於檢查和清潔海水過濾器的更多資訊。
Caterpillar Information System:
C9.3 Engines for Caterpillar Built Machines Lubrication System
3500 Industrial and Generator Set Engines Auxiliary Water Pump - Inspect - if equipped
3500 and 3500B Engines Heat Exchanger - Inspect - if equipped
C13 and C15 On-highway Engines Air Shutoff - Test
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Remove
C18 Marine Generator Set Engines Sensors and Electrical Connectors
C9 Marine Auxiliary and Marine Generator Set Engines Coolant Temperature Is Too High
C27 and C32 Industrial and Petroleum Engines System Configuration Parameters
C13 and C15 On-highway Engines Sensor Signal (PWM) - Test
2005/06/06 Prevent Spontaneous Engine Shutdown {1000}
2005/06/06 New Inlet Manifold Pressure Sensors are Available {1058, 1923}
3406E and C15 Marine Engines Coolant Level Sensor - Remove and Install
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Install
C7 On-highway Engine Fuel Filter Base
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Disassemble
C7 and C9 On-Highway Engines Air Inlet Heater - Test
C13 and C15 On-highway Engines Coolant Level - Test
G3500 Engines Air Starting Motor - Assemble
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Assemble
3500 Generator Sets Electrical System
PL1000E Communication ECM General Information
3406E Marine Engine Engine Support (Front) - Remove and Install
C11 and C13 Engines Valve Rocker Arm
C9 Engine for Caterpillar Built Machines Water Temperature Regulator - Remove and Install