Engine Support (Front) - Remove and Install
拆卸步骤
- 支撑发动机。
Show/hide table
图 1 | g01173051 |
- 将适当的起吊设备连接到前发动机支架 (5) 。 前发动机支架 (5) 的重量约为 36 kg (80 lb)。 拆下固定螺钉 (1) 和螺栓 (4) 。 拆下前发动机支架 (5) 。
- 拆下螺栓 (3) 和发动机支架 (2) 。
安装步骤
- 将发动机支架 (2) 紧挨缸体,然后安装螺栓 (3) 。
Show/hide table
图 2 | g01173051 |
- 将适当的起吊设备连接到前发动机支架 (5) 。 前发动机支架 (5) 的重量约为 36 kg (80 lb)。 安置前发动机支架 (5) ,然后安装螺栓 (4) 和固定螺钉 (1) 。
- 拧紧螺栓 (4) 至扭矩为 475 ± 60 N·m (350 ± 44 lb ft)。 拧紧固定螺钉 (1) 的螺母至扭矩为 45 ± 7 N·m (33 ± 5 lb ft)。
Caterpillar Information System:
PL1000E Communication ECM General Information
3500 Generator Sets Electrical System
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Assemble
G3500 Engines Air Starting Motor - Assemble
C13 and C15 On-highway Engines Coolant Level - Test
C7 and C9 On-Highway Engines Air Inlet Heater - Test
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Disassemble
C7 On-highway Engine Fuel Filter Base
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Install
3500 Industrial and Generator Set Engines Sea Water Strainer - Clean/Inspect - if equipped
C9.3 Engines for Caterpillar Built Machines Lubrication System
3500 Industrial and Generator Set Engines Auxiliary Water Pump - Inspect - if equipped
C11 and C13 Engines Valve Rocker Arm
C9 Engine for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
C13 and C15 On-highway Engines Injector Trim File - Install
C4.4 Industrial Engine Engine Valve Lash - Inspect/Adjust
C4.4 Industrial Engine Fuel Tank Water and Sediment - Drain
C4.4 (Mech) Industrial Engine Starting Motor - Inspect
C9 Engine for Caterpillar Built Machines Flywheel - Remove and Install
C7 On-highway Engine Fuel System - Prime
C7 On-highway Engine Fuel System Pressure - Test
PL1000E Communication ECM Features
C9 Engine for Caterpillar Built Machines Crankshaft Front Seal - Remove
C27 and C32 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test