Crankshaft Front Seal - Remove
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
A | 1U-7600 | 滑锤拉拔器 | 1 |
B | 1U-8145 | 钻头 | 1 |
开始:
- 拆下减振器和皮带轮。 请参阅拆解和组装, "减振器和皮带轮 - 拆卸和安装"。
- 使用工具 (B),在曲轴前油封 (1) 上小心钻出三个等距的孔。
- 交替在钻孔间使用工具 (A),拆下曲轴前油封 (1)。
Show/hide table
图 1 | g01276176 |
Caterpillar Information System:
PL1000E Communication ECM Features
C7 On-highway Engine Fuel System Pressure - Test
C7 On-highway Engine Fuel System - Prime
C9 Engine for Caterpillar Built Machines Flywheel - Remove and Install
C4.4 (Mech) Industrial Engine Starting Motor - Inspect
C4.4 Industrial Engine Fuel Tank Water and Sediment - Drain
C4.4 Industrial Engine Engine Valve Lash - Inspect/Adjust
C13 and C15 On-highway Engines Injector Trim File - Install
C9 Engine for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
C11 and C13 Engines Valve Rocker Arm
3406E Marine Engine Engine Support (Front) - Remove and Install
PL1000E Communication ECM General Information
C27 and C32 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
PL1000E Communication ECM Electronic Control Module (ECM)
C27 and C32 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor - Calibrate
C9 Engine for Caterpillar Built Machines Crankshaft Front Seal - Install
PL1000E Communication ECM General Information
C7 PETROLEUM Petroleum Engine Front Cover - Remove and Install
PL1000E Communication ECM Service Tools
PL1000E Communication ECM Connector Locations
PL1000E Communication ECM Diagnostic Capabilities
C9 Engine for Caterpillar Built Machines Housing (Front) - Remove
C9 Engine for Caterpillar Built Machines Housing (Front) - Install
C15 and C18 Petroleum Generator Sets Engine Air Cleaner Service Indicator - Inspect