Electronic Control Module (ECM)
Show/hide table
 | |
| Illustration 1 | g01705933 |
PL1000E Communication ECM | |
Show/hide table
 | |
| Illustration 2 | g01720098 |
Locations of the ECM connector pins. Rear view of connector. | |
Caterpillar Information System:
C27 and C32 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
C9 Engine for Caterpillar Built Machines Crankshaft Front Seal - Remove
PL1000E Communication ECM Features
C7 On-highway Engine Fuel System Pressure - Test
C7 On-highway Engine Fuel System - Prime
C9 Engine for Caterpillar Built Machines Flywheel - Remove and Install
C4.4 (Mech) Industrial Engine Starting Motor - Inspect
C4.4 Industrial Engine Fuel Tank Water and Sediment - Drain
C4.4 Industrial Engine Engine Valve Lash - Inspect/Adjust
C13 and C15 On-highway Engines Injector Trim File - Install
C9 Engine for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
C11 and C13 Engines Valve Rocker Arm
C27 and C32 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor - Calibrate
C9 Engine for Caterpillar Built Machines Crankshaft Front Seal - Install
PL1000E Communication ECM General Information
C7 PETROLEUM Petroleum Engine Front Cover - Remove and Install
PL1000E Communication ECM Service Tools
PL1000E Communication ECM Connector Locations
PL1000E Communication ECM Diagnostic Capabilities
C9 Engine for Caterpillar Built Machines Housing (Front) - Remove
C9 Engine for Caterpillar Built Machines Housing (Front) - Install
C15 and C18 Petroleum Generator Sets Engine Air Cleaner Service Indicator - Inspect
3508B, 3508C, 3512B, 3512C, 3516B and and 3516C Marine Engines Turbocharger - Inspect
C280 Marine, Marine Auxiliary, and Petroleum Engines Engine Protective Devices - Check