Crankshaft Front Seal - Install
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
C | 1U-7430 | 前油封安装工具 | 1 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 使用工具 (C) 安装曲轴前油封 (1)。
Show/hide table
图 1 | g01276301 |
注: 曲轴前油封设计为在干燥时安装。
结束:
- 安装减振器和皮带轮。 请参阅拆解和组装, "减振器和皮带轮 - 拆卸和安装"。
Caterpillar Information System:
C27 and C32 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor - Calibrate
PL1000E Communication ECM Electronic Control Module (ECM)
C27 and C32 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
C9 Engine for Caterpillar Built Machines Crankshaft Front Seal - Remove
PL1000E Communication ECM Features
C7 On-highway Engine Fuel System Pressure - Test
C7 On-highway Engine Fuel System - Prime
C9 Engine for Caterpillar Built Machines Flywheel - Remove and Install
C4.4 (Mech) Industrial Engine Starting Motor - Inspect
C4.4 Industrial Engine Fuel Tank Water and Sediment - Drain
C4.4 Industrial Engine Engine Valve Lash - Inspect/Adjust
C13 and C15 On-highway Engines Injector Trim File - Install
PL1000E Communication ECM General Information
C7 PETROLEUM Petroleum Engine Front Cover - Remove and Install
PL1000E Communication ECM Service Tools
PL1000E Communication ECM Connector Locations
PL1000E Communication ECM Diagnostic Capabilities
C9 Engine for Caterpillar Built Machines Housing (Front) - Remove
C9 Engine for Caterpillar Built Machines Housing (Front) - Install
C15 and C18 Petroleum Generator Sets Engine Air Cleaner Service Indicator - Inspect
3508B, 3508C, 3512B, 3512C, 3516B and and 3516C Marine Engines Turbocharger - Inspect
C280 Marine, Marine Auxiliary, and Petroleum Engines Engine Protective Devices - Check
C280 Marine, Marine Auxiliary, and Petroleum Engines Overhaul (Major)
C280 Marine, Marine Auxiliary, and Petroleum Engines Overhaul (Top End)