Fuel Filter Base
Show/hide table
Illustration 1 | g01636468 |
Top view |
(1) Torque for the bolt ... 25 ± 6 N·m (18 ± 4 lb ft)
(2) Torque for the bolt ... 13 ± 3 N·m (115 ± 27 lb in)
(A) Angle for tightening adapter tee ... 25 ± 3 degrees
Show/hide table
Illustration 2 | g01570838 |
(B) Distance from the sealing surface of the filter base to the end of the stud ... 24.7 ± 1.3 mm (0.97 ± 0.05 inch)
Show/hide table
Illustration 3 | g01570840 |
(C) Length for applying 154-9731 Thread Lock Compound to the tapered end of the stud ... 7.6 ± 1.5 mm (0.30 ± 0.06 inch)
(3) Torque for the fuel filter insert ... 68 ± 7 N·m (50 ± 5 lb ft)
Caterpillar Information System:
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Install
3500 Industrial and Generator Set Engines Sea Water Strainer - Clean/Inspect - if equipped
C9.3 Engines for Caterpillar Built Machines Lubrication System
3500 Industrial and Generator Set Engines Auxiliary Water Pump - Inspect - if equipped
3500 and 3500B Engines Heat Exchanger - Inspect - if equipped
C13 and C15 On-highway Engines Air Shutoff - Test
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Remove
C18 Marine Generator Set Engines Sensors and Electrical Connectors
C9 Marine Auxiliary and Marine Generator Set Engines Coolant Temperature Is Too High
C27 and C32 Industrial and Petroleum Engines System Configuration Parameters
C13 and C15 On-highway Engines Sensor Signal (PWM) - Test
2005/06/06 Prevent Spontaneous Engine Shutdown {1000}
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Disassemble
C7 and C9 On-Highway Engines Air Inlet Heater - Test
C13 and C15 On-highway Engines Coolant Level - Test
G3500 Engines Air Starting Motor - Assemble
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Assemble
3500 Generator Sets Electrical System
PL1000E Communication ECM General Information
3406E Marine Engine Engine Support (Front) - Remove and Install
C11 and C13 Engines Valve Rocker Arm
C9 Engine for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
C13 and C15 On-highway Engines Injector Trim File - Install
C4.4 Industrial Engine Engine Valve Lash - Inspect/Adjust