C9 Engine for Caterpillar Built Machines Caterpillar


Engine Oil Pump - Remove

Usage:

MH3049 HPB

拆卸步骤

表 1
所需工具 
工具  零件号  零件描述  数量 
1P-0510  冲头总成 

开始:

  1. 拆下发动机油底壳。 请参阅拆解和组装, "发动机油底壳 - 拆卸和安装"。


注意

保持所有零件清洁无杂质。

杂质会造成快速磨损和缩短部件寿命。



注意

在进行检验、保养、测试、调整及维修产品期间,必须小心以确保装好排放出的油液。 在打开任何舱室或解体任何储有液体的部件之前,要准备好合适的容器收集液体。

有关收集和盛接 Cat 产品上油液的适用工具和用品,请参阅专门出版物, NENG2500, "代理商维修工具目录"。

按照当地法规和要求处置所有液体。




    图 1g01172390

  1. 拆下螺栓 (4)。

  2. 拆下螺栓 (3)。

  3. 拆下螺栓 (2),然后拆下发动机机油泵 (1)。

  4. 拆下缸体与排气弯头之间的 O 形密封圈。


    图 2g01172397

  5. 拆下螺栓 (7),然后卸下出口弯头 (8)。

  6. 卸下螺栓 (5)。 拆下吸油管 (6) 和密封垫。


    图 3g01172401

  7. 拆下螺栓 (12) 和垫圈。 拆卸惰齿轮 (11)。 使用工具 (A) 从惰齿轮 (11) 上拆卸轴承 (10)。 从发动机机油泵 (1) 上拆下轴 (9)。

Caterpillar Information System:

C18 Marine Generator Set Engines Sensors and Electrical Connectors
C9 Marine Auxiliary and Marine Generator Set Engines Coolant Temperature Is Too High
C27 and C32 Industrial and Petroleum Engines System Configuration Parameters
C13 and C15 On-highway Engines Sensor Signal (PWM) - Test
2005/06/06 Prevent Spontaneous Engine Shutdown {1000}
2005/06/06 New Inlet Manifold Pressure Sensors are Available {1058, 1923}
3406E and C15 Marine Engines Coolant Level Sensor - Remove and Install
2005/05/30 New Strainer for the Air Starting Motor {1451}
3406E Marine Engine Coolant Temperature Sensor - Remove and Install
C32 Petroleum Engines Plate Locations and Film Locations
3406E and C15 Marine Engines Engine Oil Pressure Sensor - Remove and Install
3406E and C15 Marine Engines Crankshaft Position Sensor - Remove and Install
C13 and C15 On-highway Engines Air Shutoff - Test
3500 and 3500B Engines Heat Exchanger - Inspect - if equipped
3500 Industrial and Generator Set Engines Auxiliary Water Pump - Inspect - if equipped
C9.3 Engines for Caterpillar Built Machines Lubrication System
3500 Industrial and Generator Set Engines Sea Water Strainer - Clean/Inspect - if equipped
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Install
C7 On-highway Engine Fuel Filter Base
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Disassemble
C7 and C9 On-Highway Engines Air Inlet Heater - Test
C13 and C15 On-highway Engines Coolant Level - Test
G3500 Engines Air Starting Motor - Assemble
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Assemble
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.