Sensors and Electrical Connectors
Show/hide table
Illustration 1 | g01388212 |
Components for the engine's control system |
Show/hide table
Illustration 2 | g01172356 |
Left side engine view (typical example) (1) Engine coolant temperature sensor (2) Coolant level sensor (3) Fuel temperature sensor (4) Fuel outlet temperature sensor (5) Valve cover connectors for the injector solenoids (6) Intake manifold air temperature sensor (7) Turbocharger outlet pressure sensor (8) J60 Service tool connector (9) J61 Customer connector (10) Starting motor magnetic switch (SMMS) (11) Secondary engine speed/timing sensor (12) Primary engine speed/timing sensor (13) Timing calibration port (14) Fuel pressure sensor (15) Atmospheric sensor (16) Engine oil pressure sensor (17) P400 Timing calibration probe connector (18) J2/P2 ECM connectors (19) J1/P1 ECM connectors |
Show/hide table
Illustration 3 | g01173198 |
Right side engine view (typical example) (20) Magnetic speed sensor |
Caterpillar Information System:
C9 Marine Auxiliary and Marine Generator Set Engines Coolant Temperature Is Too High
C27 and C32 Industrial and Petroleum Engines System Configuration Parameters
C13 and C15 On-highway Engines Sensor Signal (PWM) - Test
2005/06/06 Prevent Spontaneous Engine Shutdown {1000}
2005/06/06 New Inlet Manifold Pressure Sensors are Available {1058, 1923}
3406E and C15 Marine Engines Coolant Level Sensor - Remove and Install
2005/05/30 New Strainer for the Air Starting Motor {1451}
3406E Marine Engine Coolant Temperature Sensor - Remove and Install
C32 Petroleum Engines Plate Locations and Film Locations
3406E and C15 Marine Engines Engine Oil Pressure Sensor - Remove and Install
3406E and C15 Marine Engines Crankshaft Position Sensor - Remove and Install
3406E Marine Engine Fuel Pressure Sensor - Remove and Install
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Remove
C13 and C15 On-highway Engines Air Shutoff - Test
3500 and 3500B Engines Heat Exchanger - Inspect - if equipped
3500 Industrial and Generator Set Engines Auxiliary Water Pump - Inspect - if equipped
C9.3 Engines for Caterpillar Built Machines Lubrication System
3500 Industrial and Generator Set Engines Sea Water Strainer - Clean/Inspect - if equipped
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Install
C7 On-highway Engine Fuel Filter Base
C9 Engine for Caterpillar Built Machines Engine Oil Pump - Disassemble
C7 and C9 On-Highway Engines Air Inlet Heater - Test
C13 and C15 On-highway Engines Coolant Level - Test
G3500 Engines Air Starting Motor - Assemble