Engine Oil Pump - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
If any of the parts on the engine oil pump are worn or damaged, the entire pump must be replaced. |
- Install engine oil pump (9). Install bolts (8). Tighten bolts (8) to a torque of
9 N·m (80 lb in) . - Fill engine oil pump (9) with clean engine oil.
- Position engine oil pump assembly (2) against the cylinder block. Ensure that dowel pin (10) and hollow dowel (11) are correctly located in the cylinder block.
- Install bolts (1). Tighten bolts (1) to a torque of
44 N·m (32 lb ft) .Show/hide tableIllustration 2 g00956781 Show/hide tableImproper assembly of parts that are spring loaded can cause bodily injury.
To prevent possible injury, follow the established assembly procedure and wear protective equipment.
- Clean spring (6) and plunger (7) of the engine oil relief valve. Lubricate spring (6) and plunger (7) with clean engine oil.
- Install plunger (7), spring (6), and plug (5) in engine oil pump assembly (2). Tighten plug (5) to a torque of
22 N·m (16 lb ft) . - Position suction pipe (4) and install bolts (3).
Show/hide table
Illustration 1 | g00956778 |
End By:
- Install the oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Caterpillar Information System:
C3.3 and C4.4 Generator Sets Engine Oil Pump - Remove
Dynamometer Testing of Caterpillar Engines {0781, 1000} Dynamometer Testing of Caterpillar Engines {0781, 1000}
C9 Generator Set Engines Air Inlet and Exhaust System
3500B and 3500C Generator Set Engines Cat Data Link
C6.6 Industrial Engine Engine Oil and Filter - Change
C280 Marine and Petroleum Engines Lubrication System Operation
325D and 329D Excavators Cab Door
C7 On-highway Engine Valve Mechanism Cover
C3.3 and C4.4 Generator Sets Engine Oil Relief Valve - Remove and Install
C4.4 Marine Generator Set Engines Engine Oil Cooler - Install
C4.4 Marine Generator Set Engines Engine Oil Cooler - Remove
C280 Marine Engines Aftercooler
C280 Marine and Petroleum Engines Pistons, Rings and Connecting Rods
3500B and 3500C Generator Set Engines Digital Sensor Supply
C6.6 Industrial Engine Fuel System - Prime
C6.6 Industrial Engine Fuel System Secondary Filter - Replace
C4.4 Marine Auxiliary Generator Set Engine Fuel Filter (Primary)
C4.4 Marine Generator Set Engines Water Pump - Remove and Install
C4.4 Marine Auxiliary Generator Set Engine Water Lines - Engines with a Heat Exchanger
C4.4 Industrial Engine Turbocharger - Inspect
C4.4 Marine Generator Set Engines Water Temperature Regulator - Remove and Install
G3400 Engines (EIS) Inspecting Electrical Connectors
C4.4 Marine Generator Set Engines Flywheel - Remove
C4.4 Marine Generator Set Engines Flywheel - Install