Air Inlet Heater - Remove and Install
Removal Procedure
Start By:
- Remove the aftercooler. Refer to Disassembly and Assembly, "Aftercooler - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Loosen nuts (1) while you hold bolts (3) with a wrench.
Show/hide table
Illustration 1 | g00748327 |
Note: Use a wrench to hold the bolt head when you loosen the nut for the harness assembly on the air inlet heater. Hold the bolt head in position in order to prevent pressure on the heater element.
- Slide the slotted ends of air inlet heater (2) from bolts (3) .
- Remove air inlet heater (2) .
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position air inlet heater (2) in the aftercooler.
Show/hide table
Illustration 2 | g00748327 |
- Slide the slotted ends of air inlet heater (2) between bolts (3) and the aftercooler.
- Tighten nuts (1) while you hold bolts (3) with a wrench.
Note: Use a wrench to hold the bolt head when you tighten the nut for the harness assembly on the air inlet heater. Hold the bolt head in position in order to prevent pressure on the heater element.
End By: Install the aftercooler. Refer to Disassembly and Assembly, "Aftercooler - Install".
Caterpillar Information System:
2004/08/01 An Improved Unit Injector Hydraulic Pump Group is Now Available. {1714}
C15 On-highway Engines Air Compressor - Remove and Install
C15 On-highway Engines Engine Oil Pan - Remove and Install
G3500 Engines Refill Capacities and Recommendations
C7 Marine Engines Exhaust Manifold - Remove and Install
C15 On-highway Engines Valve Mechanism Cover Base - Remove and Install
C7 Marine Engines Turbocharger - Install
C7 Marine Engines Turbocharger - Remove
C7 Marine Engines Unit Injector Hydraulic Pump - Install
C15 and C18 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
C7 Marine Engines Unit Injector Hydraulic Pump - Remove
C7 Marine Engines Injection Actuation Pressure Control Valve - Install
C7 Marine Engines Air Inlet Heater Solenoid - Remove and Install
C7 Marine Engines Inlet and Exhaust Valves - Remove and Install
G3500B Engines Gas Engine Ignition
C7 Marine Engines Engine Oil Filter Base - Remove
Generator Set Start Module (AC Input) General Hazard Information
C7 Marine Engines Engine Oil Filter Base - Disassemble
C7 Marine Engines Engine Oil Filter Base - Assemble
C7 Marine Engines Engine Oil Filter Base - Install
C7 Urban Transit Bus Engines Gauges and Indicators
C7 Marine Engines Engine Oil Cooler - Remove
C7 Marine Engines Engine Oil Cooler - Install
2004/12/13 New Software is Now Used to Ensure Charging at Low Engine Speed {7620}