Engine Oil Filter Base - Assemble
Assembly Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect the condition of the O-ring seals. Replace the O-ring seals, if necessary. The contact surfaces of the O-ring seals must be clean and dry.
- Install O-ring seal (5) on plug (2). Apply clean engine oil to O-ring seal (5) and valve (3) .
Show/hide table
Illustration 1 | g01089928 |
Show/hide table
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
- Install valve (3) and spring (4) in engine oil filter base (1) .
- Install plug (2) in engine oil filter base (1) .
End By: Install the engine oil filter base. Refer to Disassembly and Assembly, "Engine Oil Filter Base - Install".
Caterpillar Information System:
C7 Marine Engines Engine Oil Filter Base - Disassemble
Generator Set Start Module (AC Input) General Hazard Information
C7 Marine Engines Engine Oil Filter Base - Remove
G3500B Engines Gas Engine Ignition
C7 Marine Engines Inlet and Exhaust Valves - Remove and Install
C7 Marine Engines Air Inlet Heater Solenoid - Remove and Install
C7 Marine Engines Air Inlet Heater - Remove and Install
2004/08/01 An Improved Unit Injector Hydraulic Pump Group is Now Available. {1714}
C15 On-highway Engines Air Compressor - Remove and Install
C15 On-highway Engines Engine Oil Pan - Remove and Install
G3500 Engines Refill Capacities and Recommendations
C7 Marine Engines Exhaust Manifold - Remove and Install
C7 Marine Engines Engine Oil Filter Base - Install
C7 Urban Transit Bus Engines Gauges and Indicators
C7 Marine Engines Engine Oil Cooler - Remove
C7 Marine Engines Engine Oil Cooler - Install
2004/12/13 New Software is Now Used to Ensure Charging at Low Engine Speed {7620}
C7 Urban Transit Bus Engines Engine Operation
G3500 Engines Maintenance Interval Schedule - Naturally Aspirated
G3500 Engines Maintenance Interval Schedule - Turbocharged Aftercooled
C7 Marine Engines Water Pump - Remove
C15 On-highway Engine Engine Oil Filter Base - Disassemble
C15 On-highway Engine Engine Oil Filter Base - Assemble
345C MHPU Mobile Hydraulic Power Unit Cooling System Coolant Sample (Level 1) - Obtain