Engine Oil Cooler - Install
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 1U-6396     | O-Ring Assembly Compound     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Lubricate all O-ring seals with Tooling (A) .
- Position the gasket and engine oil cooler (8) on the engine.
Show/hide table
Illustration 1 | g01090686 |
Show/hide table
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
- Position the gasket and oil cooler base (7) on the engine.
- Install bolts (6) .
- Install engine oil cooler bypass valve (5) .
- Position housing (4) on the oil cooler base. Install bolts (3) .
Show/hide table
Illustration 2 | g01078897 |
- Connect tube assemblies (2). Install hose assembly (1) .
End By: Install the heat exchanger. Refer to Disassembly and Assembly, "Heat Exchanger - Install".
Caterpillar Information System:
C7 Marine Engines Engine Oil Cooler - Remove
C7 Urban Transit Bus Engines Gauges and Indicators
C7 Marine Engines Engine Oil Filter Base - Install
C7 Marine Engines Engine Oil Filter Base - Assemble
C7 Marine Engines Engine Oil Filter Base - Disassemble
Generator Set Start Module (AC Input) General Hazard Information
C7 Marine Engines Engine Oil Filter Base - Remove
G3500B Engines Gas Engine Ignition
C7 Marine Engines Inlet and Exhaust Valves - Remove and Install
C7 Marine Engines Air Inlet Heater Solenoid - Remove and Install
C7 Marine Engines Air Inlet Heater - Remove and Install
2004/08/01 An Improved Unit Injector Hydraulic Pump Group is Now Available. {1714}
2004/12/13 New Software is Now Used to Ensure Charging at Low Engine Speed {7620}
C7 Urban Transit Bus Engines Engine Operation
G3500 Engines Maintenance Interval Schedule - Naturally Aspirated
G3500 Engines Maintenance Interval Schedule - Turbocharged Aftercooled
C7 Marine Engines Water Pump - Remove
C15 On-highway Engine Engine Oil Filter Base - Disassemble
C15 On-highway Engine Engine Oil Filter Base - Assemble
345C MHPU Mobile Hydraulic Power Unit Cooling System Coolant Sample (Level 1) - Obtain
C7 Marine Engines Water Pump - Install
C7 Marine Engines Water Temperature Regulator - Remove and Install - Keel Cooled System
C7 Marine Engines Auxiliary Water Pump - Remove
3126B Petroleum Engine Auxiliary Water Pump - Disassemble