Auxiliary Water Pump - Remove
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect hose (1) and hose (7) .
Show/hide table
Illustration 1 | g01079297 |
- Remove bolts (5). Remove lower elbow (6) and the O-ring seal.
- Remove bolts (4) .
- Rotate auxiliary water pump (3) away from tube (2). Remove auxiliary water pump (3) and the gasket.
Caterpillar Information System:
C7 Marine Engines Water Temperature Regulator - Remove and Install - Keel Cooled System
C7 Marine Engines Water Pump - Install
345C MHPU Mobile Hydraulic Power Unit Cooling System Coolant Sample (Level 1) - Obtain
C15 On-highway Engine Engine Oil Filter Base - Assemble
C15 On-highway Engine Engine Oil Filter Base - Disassemble
C7 Marine Engines Water Pump - Remove
G3500 Engines Maintenance Interval Schedule - Turbocharged Aftercooled
G3500 Engines Maintenance Interval Schedule - Naturally Aspirated
C7 Urban Transit Bus Engines Engine Operation
2004/12/13 New Software is Now Used to Ensure Charging at Low Engine Speed {7620}
C7 Marine Engines Engine Oil Cooler - Install
C7 Marine Engines Engine Oil Cooler - Remove
3126B Petroleum Engine Auxiliary Water Pump - Disassemble
C7 Marine Engines Auxiliary Water Pump - Assemble
3126B Industrial Engines Replacing the ECM
3406E and 3456 Generator Set Engines CID 0091 FMI 08 Throttle Position signal abnormal
C7 Marine Engines Auxiliary Water Pump - Install
345C MHPU Mobile Hydraulic Power Unit Cooling System Coolant (ELC) - Change
3406E and 3456 Generator Set Engines CID 0100 FMI 03 Engine Oil Pressure open/short to +batt
3406E and 3456 Generator Set Engines CID 0100 FMI 13 Engine Oil Pressure calibration required
3406E and 3456 Generator Set Engines CID 0110 FMI 03 Engine Coolant Temperature open/short to +batt
3406E and 3456 Generator Set Engines CID 0110 FMI 04 Engine Coolant Temperature short to ground
C7 Marine Engines Aftercooler - Remove
3406E and 3456 Generator Set Engines CID 0168 FMI 00 System Voltage High