Water Pump - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position water pump (8) and install bolts (9) .
Show/hide table
Illustration 1 | g01092606 |
- Tighten hose clamp (7) .
- Connect hose (5) and hose (6) .
- Position bracket (4) and the alternator. Install bolts (3) .
- Install drive belt (2) .
- Install guard (1) .
Show/hide table
Illustration 2 | g01079198 |
- Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Caterpillar Information System:
345C MHPU Mobile Hydraulic Power Unit Cooling System Coolant Sample (Level 1) - Obtain
C15 On-highway Engine Engine Oil Filter Base - Assemble
C15 On-highway Engine Engine Oil Filter Base - Disassemble
C7 Marine Engines Water Pump - Remove
G3500 Engines Maintenance Interval Schedule - Turbocharged Aftercooled
G3500 Engines Maintenance Interval Schedule - Naturally Aspirated
C7 Urban Transit Bus Engines Engine Operation
2004/12/13 New Software is Now Used to Ensure Charging at Low Engine Speed {7620}
C7 Marine Engines Engine Oil Cooler - Install
C7 Marine Engines Engine Oil Cooler - Remove
C7 Urban Transit Bus Engines Gauges and Indicators
C7 Marine Engines Engine Oil Filter Base - Install
C7 Marine Engines Water Temperature Regulator - Remove and Install - Keel Cooled System
C7 Marine Engines Auxiliary Water Pump - Remove
3126B Petroleum Engine Auxiliary Water Pump - Disassemble
C7 Marine Engines Auxiliary Water Pump - Assemble
3126B Industrial Engines Replacing the ECM
3406E and 3456 Generator Set Engines CID 0091 FMI 08 Throttle Position signal abnormal
C7 Marine Engines Auxiliary Water Pump - Install
345C MHPU Mobile Hydraulic Power Unit Cooling System Coolant (ELC) - Change
3406E and 3456 Generator Set Engines CID 0100 FMI 03 Engine Oil Pressure open/short to +batt
3406E and 3456 Generator Set Engines CID 0100 FMI 13 Engine Oil Pressure calibration required
3406E and 3456 Generator Set Engines CID 0110 FMI 03 Engine Coolant Temperature open/short to +batt
3406E and 3456 Generator Set Engines CID 0110 FMI 04 Engine Coolant Temperature short to ground