Auxiliary Water Pump - Install
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position auxiliary water pump (3) and the gasket in the front housing.
Note: Rotate the auxiliary water pump in order to clear tube (2) when you install the auxiliary water pump.
Show/hide table
 | |
| Illustration 1 | g01079297 |
- Install bolts (4) .
- Place lower elbow (6) and the O-ring seal in position. Install bolts (5). Tighten bolts (5) to a torque of 15 ± 3 N·m (11 ± 2 lb ft).
- Connect hose (1) and hose (7) .
Caterpillar Information System:
3406E and 3456 Generator Set Engines CID 0091 FMI 08 Throttle Position signal abnormal
3126B Industrial Engines Replacing the ECM
C7 Marine Engines Auxiliary Water Pump - Assemble
3126B Petroleum Engine Auxiliary Water Pump - Disassemble
C7 Marine Engines Auxiliary Water Pump - Remove
C7 Marine Engines Water Temperature Regulator - Remove and Install - Keel Cooled System
C7 Marine Engines Water Pump - Install
345C MHPU Mobile Hydraulic Power Unit Cooling System Coolant Sample (Level 1) - Obtain
C15 On-highway Engine Engine Oil Filter Base - Assemble
C15 On-highway Engine Engine Oil Filter Base - Disassemble
C7 Marine Engines Water Pump - Remove
G3500 Engines Maintenance Interval Schedule - Turbocharged Aftercooled
345C MHPU Mobile Hydraulic Power Unit Cooling System Coolant (ELC) - Change
3406E and 3456 Generator Set Engines CID 0100 FMI 03 Engine Oil Pressure open/short to +batt
3406E and 3456 Generator Set Engines CID 0100 FMI 13 Engine Oil Pressure calibration required
3406E and 3456 Generator Set Engines CID 0110 FMI 03 Engine Coolant Temperature open/short to +batt
3406E and 3456 Generator Set Engines CID 0110 FMI 04 Engine Coolant Temperature short to ground
C7 Marine Engines Aftercooler - Remove
3406E and 3456 Generator Set Engines CID 0168 FMI 00 System Voltage High
3406E and 3456 Generator Set Engines CID 0168 FMI 01 System Voltage Low
3406E and 3456 Generator Set Engines CID 0168 FMI 02 System Voltage intermittent/erratic
3406E and 3456 Generator Set Engines CID 0172 FMI 03 Intake Manifold Air Temp open/short to +batt
3406E and 3456 Generator Set Engines CID 0172 FMI 04 Intake Manifold Air Temp short to ground
C7 Marine Engines Aftercooler - Disassemble