Unit Injector Hydraulic Pump - Remove
Removal Procedure
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 180-0186 | Removal Tool | 1 |
Show/hide table
 |
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. |
 |
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Use Tooling (A) in order to remove hose assembly (1) .
Show/hide table
 | |
| Illustration 1 | g01078491 |
- Remove tube assembly (4) .
- Disconnect harness assembly (3) .
- Remove return tube assembly (5) from the engine block and fitting (2) .
- Remove bolts (6) and remove the unit injector hydraulic pump from the timing gear housing.
- Remove O-ring seal (7) from the unit injector hydraulic pump.
Show/hide table
 | |
| Illustration 2 | g01078646 |
- Remove bolt (8) and washer (9). Remove drive gear (10) and inspect drive gear (10) .
Caterpillar Information System:
C7 Marine Engines Injection Actuation Pressure Control Valve - Install
C7 Marine Engines Injection Actuation Pressure Control Valve - Remove
325D and 329D Excavators Air Conditioning and Heating Control
C11 and C13 Engines for Caterpillar Built Machines Air Inlet and Exhaust System
G3500 Engines Plate Locations and Film Locations
G3500 Engines Specifications
324D and 326D Excavators Work Tool Control Pedal - If Equipped
Fabricated Tool for Alternate Method of Tightening Fan Drive Belts{1357, 1397} Fabricated Tool for Alternate Method of Tightening Fan Drive Belts{1357, 1397}
G3520B Industrial Engine System Configuration Parameters
2006/02/13 Two Adjustment Gauges Help the Technician Set the Lash for the Variable Valve Actuators {0703, 0763, 1100, 1209}
C7 Marine Engines Fuel Transfer Pump - Install
G3520B Industrial Engine Electronic Service Tools
C15 and C18 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
C7 Marine Engines Unit Injector Hydraulic Pump - Install
C7 Marine Engines Turbocharger - Remove
C7 Marine Engines Turbocharger - Install
C15 On-highway Engines Valve Mechanism Cover Base - Remove and Install
C7 Marine Engines Exhaust Manifold - Remove and Install
G3500 Engines Refill Capacities and Recommendations
C15 On-highway Engines Engine Oil Pan - Remove and Install
C15 On-highway Engines Air Compressor - Remove and Install
2004/08/01 An Improved Unit Injector Hydraulic Pump Group is Now Available. {1714}
C7 Marine Engines Air Inlet Heater - Remove and Install
C7 Marine Engines Air Inlet Heater Solenoid - Remove and Install