Turbocharger - Remove
Removal Procedure
Show/hide table
 |
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. |
 |
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Drain the coolant system. Refer to Operation and Maintenance Manual, "Refill Capacities and Recommendations".
- Disconnect hose (2) .
Show/hide table
 | |
| Illustration 1 | g01078559 |
- Disconnect tube assembly (1) .
- Remove bolts (3) and the retaining plates.
- Remove elbow (4) .
- Disconnect tube assembly (5) .
- Remove bolts (6) and tube assembly (7) .
- Disconnect hose (8) .
- Remove nuts (10), turbocharger (9), and the gasket.
Show/hide table
 | |
| Illustration 2 | g01078627 |
Caterpillar Information System:
C7 Marine Engines Unit Injector Hydraulic Pump - Install
C15 and C18 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
C7 Marine Engines Unit Injector Hydraulic Pump - Remove
C7 Marine Engines Injection Actuation Pressure Control Valve - Install
C7 Marine Engines Injection Actuation Pressure Control Valve - Remove
325D and 329D Excavators Air Conditioning and Heating Control
C11 and C13 Engines for Caterpillar Built Machines Air Inlet and Exhaust System
G3500 Engines Plate Locations and Film Locations
G3500 Engines Specifications
324D and 326D Excavators Work Tool Control Pedal - If Equipped
Fabricated Tool for Alternate Method of Tightening Fan Drive Belts{1357, 1397} Fabricated Tool for Alternate Method of Tightening Fan Drive Belts{1357, 1397}
G3520B Industrial Engine System Configuration Parameters
C7 Marine Engines Turbocharger - Install
C15 On-highway Engines Valve Mechanism Cover Base - Remove and Install
C7 Marine Engines Exhaust Manifold - Remove and Install
G3500 Engines Refill Capacities and Recommendations
C15 On-highway Engines Engine Oil Pan - Remove and Install
C15 On-highway Engines Air Compressor - Remove and Install
2004/08/01 An Improved Unit Injector Hydraulic Pump Group is Now Available. {1714}
C7 Marine Engines Air Inlet Heater - Remove and Install
C7 Marine Engines Air Inlet Heater Solenoid - Remove and Install
C7 Marine Engines Inlet and Exhaust Valves - Remove and Install
G3500B Engines Gas Engine Ignition
C7 Marine Engines Engine Oil Filter Base - Remove