Camshaft
Show/hide table
图 1 | g01182785 |
(1) 排气凸尖
(2) 以下尺寸位于上图所示位置。
- 新止推垫圈厚度 ... 4.70 mm (0.185 in)
- 至 ... 4.76 mm (0.187 in)
- 新凸轮轴轴向间隙 ... 0.10 ± 0.08 mm (0.0039 ± 0.0031 in)
- 磨损凸轮轴的最大可允许轴向间隙 ... 0.46 mm (0.018 in)
- 至 ... 4.76 mm (0.187 in)
(3) 进气凸尖
(4) 凸轮轴轴颈直径 ... 65.126 ± 0.013 mm (2.5640 ± 0.0005 in)
Show/hide table
图 2 | g00923332 |
(5) 凸轮高度
- 排气凸尖 ... 6.858 mm (0.2700 in)
- 进气凸尖 ... 8.655 mm (0.3407 in)
采用以下步骤来确定凸轮高度:
- 测量凸轮轴凸尖高度 (6) 。
- 测量基圆 (7) 。
- 将步骤 2 中得到的基圆数值从步骤1中得到的凸轮轴凸轮高度中减去。 差值是实际的凸轮生成 (5) 。
新凸轮的实际凸轮高度和规定凸轮高度的最大可允许差值 ... ± 0.10 mm (.004 in)
Caterpillar Information System:
C-15 Petroleum Engine Aftercooler - Remove
C-15 Petroleum Engine Aftercooler - Install
3126B Petroleum Engine Engine Oil and Filter - Change
G3520C and G3520E Engines Water Pump
C7 On-highway Engine Air Compressor
3126B Petroleum Engine Refill Capacities and Recommendations
C-15 Petroleum Engine Auxiliary Water Pump - Assemble
C-15 Petroleum Engine Auxiliary Water Pump - Disassemble
3126B Petroleum Engine Diagnostic Flash Code Retrieval
3516B and 3516B High Displacement Engines for 994D and 994F Wheel Loaders Accessory Drive (Upper Left Hand)
SCJ and 8SC Series Alternators Stator - Test
SCJ and 8SC Series Alternators Field Winding - Test
C-15 Petroleum Engine Fuel Priming Pump - Remove and Install
C-15 Petroleum Engine Fuel Filter Base - Remove
C-15 Petroleum Engine Fuel Filter Base - Install
C9 Urban Transit Bus Engine Air Inlet Elbow
3126B Petroleum Engine Reference Material
C13, C15, and C18 Generator Set Engines Basic Engine
C13 Engines Engine Oil Level - Check
C-15 Petroleum Engine Air Inlet and Exhaust System
2004/03/29 New High Temperature Seals are Available {7555}
C-15 Petroleum Engine Engine Oil Filter Base - Install
C-15 Petroleum Engine Engine Oil Filter Base - Assemble
C-15 Petroleum Engine Engine Oil Filter Base - Disassemble