Valve Mechanism Cover - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (1) that hold valve mechanism cover (2) to the valve cover base. Remove the valve mechanism cover.
Note: If necessary, remove the breather tube from the valve mechanism cover.
Show/hide table
Illustration 1 | g01010825 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Before assembly, check the condition of the seal on the valve mechanism cover. Also check the condition of the grommets for the bolts. If the seal or the grommets are worn or damaged use a new part for replacement.
- Put valve mechanism cover (2) in position on the valve cover base. Tighten bolts (1) to a torque of
18 ± 3 N·m (13 ± 2 lb ft) in the numerical sequence that is shown in Illustration 3.
Show/hide table
Illustration 2 | g01010825 |
Show/hide table
Illustration 3 | g00579295 |
Tightening sequence |
Caterpillar Information System:
Installation of the ADEM 3 Control System on G3612 and G3616 Engines{1901, 7620} Installation of the ADEM 3 Control System on G3612 and G3616 Engines{1901, 7620}
Installation of the ADEM 3 Control System on G3606 and G3608 Engines{1901, 7620} Installation of the ADEM 3 Control System on G3606 and G3608 Engines{1901, 7620}
C15 On-highway Engine Valve Actuator (Variable) - Install
C15 On-highway Engine Valve Actuator (Variable) - Remove
C15 On-highway Engine Compression Brake - Install
C15 On-highway Engine Compression Brake - Remove
C15 On-highway Engine Compression Brake - Disassemble
C15 On-highway Engine Compression Brake - Assemble
C15 and C18 Petroleum Generator Sets Automatic Start/Stop - Inspect
C15 On-highway Engine Engine Control Module - Remove and Install
C13 Engine Turbocharger - Install - High Pressure Turbocharger
C13 Engine Turbocharger - Remove - High Pressure Turbocharger
2003/09/01 The Oil Pan Gasket now Requires a Gasket Sealant to be Used {1302, 7555}
C11 and C13 Engines Engine Oil Filter Base - Remove
C11 and C13 Engines Engine Oil Filter Base - Install
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Filter Base - Disassemble
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Filter Base - Assemble
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Pump - Remove
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Pump - Install
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Pump - Disassemble
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Pump - Assemble
C13 Engine Exhaust Manifold - Remove and Install
C11 and C13 Engines Air Compressor - Remove and Install
C13 Engine Engine Control Module - Remove and Install