C15 On-highway Engine Caterpillar

Removal Procedure

1. Disconnect the negative battery terminal at the battery.
   Show/hide table

   Illustration 1	g01010679

2. Remove nuts (1).

3. Loosen allen head screw (6). Disconnect harness assembly (2) from electronic control module (7).

4. Remove clip (4).

5. Remove nuts (5). Remove plate assembly (3).

6. Remove nuts (8). Remove the washers and the isolation mounts from the studs. Remove the electronic control module.

Installation Procedure

Show/hide table

Illustration 2	g01010679

1. Install electronic control module (7) on the isolation mounts and the studs. Install the washers and nuts (8).

2. Position plate assembly (3) and install nuts (5).

3. Install clip (4) in order to secure the harness assembly.

4. Connect the harness assembly to the electronic control module. Position cover (2) and tighten allen head screw (6). Install nuts (1) in order to secure the cover to the electronic control module.

5. Connect the negative battery terminal at the battery.