Diverter Valve (Coolant) - Assemble
Note: Inspect all O-ring seals for wear or for damage. Replace the components, if necessary.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install O-ring seals (5) on inserts (4). Install O-ring seal (10) on diaphragm (6).
- Install inserts (4), spring (7), and diaphragm (6) in body (11).
- Position cover (3) and install bolts (2).
- Install the O-ring seals on plugs (12) and install the plugs.
- Install the O-ring seal on valve cartridge (9). Install the valve cartridge and tighten to a torque of
37 ± 2 N·m (27 ± 1 lb ft) . - Install coil assembly (8). Install locknut (1) and tighten to a torque of
20 ± 3 N·m (15 ± 2 lb ft) .
Show/hide table
Illustration 1 | g01079744 |
Show/hide table
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
End By:
- Install the diverter valve. Refer to the Disassembly and Assembly Manual, "Diverter Valve - Install".
Caterpillar Information System:
2003/07/21 The Oil Pan Gasket now Requires a Gasket Sealant to be Used {1302, 7555}
C15 and C18 Engines for Caterpillar Built Machines Camshaft Gear - Remove and Install
C11 and C13 Engines Valve Mechanism Cover Base - Remove and Install
C15 and C18 Petroleum Generator Sets Cooling System Supplemental Coolant Additive (SCA) - Test/Add
C11 and C13 Engines Water Pump - Install
UPS 250 and UPS 300 Uninterruptible Power Supplies System Bypass Operation
2003/07/01 Prevent Coolant Leaks Around the Precombustion Chamber {1550}
3500B Locomotive Engines Turbocharger Support
C175–16 Locomotive Engine CAN Data Link
C7 On-highway Engine Refill Capacities and Recommendations
C7 On-highway Engine Engine Oil Level Gauge - Calibrate
C15 On-highway Engine Diverter Valve (Coolant) - Remove
C15 On-highway Engine Diverter Valve (Coolant) - Disassemble
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Generator Start-up Checklist
C13 Engine Turbocharger - Remove - High Pressure Turbocharger
C13 Engine Turbocharger - Install - High Pressure Turbocharger
C15 On-highway Engine Engine Control Module - Remove and Install
C15 and C18 Petroleum Generator Sets Automatic Start/Stop - Inspect
C15 On-highway Engine Compression Brake - Assemble
C15 On-highway Engine Compression Brake - Disassemble
C15 On-highway Engine Compression Brake - Remove
C15 On-highway Engine Compression Brake - Install
C15 On-highway Engine Valve Actuator (Variable) - Remove
C15 On-highway Engine Valve Actuator (Variable) - Install