3126B and 3126E On-highway Engines Caterpillar


0084-01 Vehicle Speed loss of signal (31)

Usage:

3126B 1AJ
产生此代码的情况:

发动机控制模块 (ECM) 检测到以下情况:

  • "VSL 保护"未编程设定在 "TEL" 上。

  • 状况指示应存在车速时,ECM 没有检测到车速。

  • 理想的发动机转速高于编程设定的 "VSL 保护"。

系统响应:

发动机转速将限定在编程设定的 "VSL 保护"上。 如果 ECM 提供转速表信号的话,则车辆行驶后发生故障时转速表可反映车速的缺失。 该故障诊断代码为激活状态时,卡特彼勒电子技师 (ET) 状态屏上"车速"旁边会显示"诊断"。 检查发动机指示灯点亮。

驾驶员可能认为发动机功率偏低,并且发动机不能达到期望转速。

注: 尽管这个事件并不常见,但是大家都知道燃油系统阻塞可导致该故障诊断代码。 这种情况存在的原因就是喷油器不能在正常负载工况下提供实现理想转速需要的足量燃油。 由于正常负载工况下 ECM 无法达到理想的转速,因此,ECM 认为车速负载。 这种情况只有在车辆行驶时才会出现。

检查燃油压力以确保车辆静止时燃油系统阻塞不是引起该故障的原因。

测试步骤 1. 进行以下的诊断步骤: 车速和车速表电路 - 测试

结果:

  • 正常 - 停止

Caterpillar Information System:

3408E and 3412E Industrial Engines Electronic Service Tools
3126B and 3126E On-highway Engines 0091-13 Throttle Position out of calibration (28)
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application 0030-13 PTO Throttle Sensor Calibration (29)
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application 0030-08 Invalid PTO Throttle Signal (29)
3054B Industrial Engine Piston Cooling Jets - Remove and Install
3126B Marine Engine Turbocharger - Install
3126B Marine Engine Turbocharger - Remove
3126B and 3126E On-highway Engines 0168-02 ECM Battery Power Intermittent (51)
3126B Marine Engine Water Pump - Assemble
3126B Engines for Caterpillar Built Machines Crankshaft Gear - Remove and Install
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Glossary
3512B Marine Auxiliary Engine Black Start Push Button
3126B and 3126E On-highway Engines 0084-02 Vehicle Speed signal invalid (36)
3126B and 3126E On-highway Engines 0084-08 Vehicle Speed signal out of range (36)
Uninterruptible Power Supply (UPS) 250 Time and Date Adjustment
3618 Engine Cylinder Liner - Install
3126B Marine Engine Auxiliary Water Pump - Disassemble
3126B and 3126E On-highway Engines 0084-10 Vehicle Speed signal rate of change (36)
3126B Marine Engine Exhaust Manifold - Remove and Install
3054B Industrial Engine Cylinder Head - Remove
Uninterruptible Power Supply (UPS) 250 Oil - Change
Uninterruptible Power Supply (UPS) 250 Display Contrast Adjustment
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Electronic Display Module - If Equipped
Uninterruptible Power Supply (UPS) 250 Oil Level - Check
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.