0084-02 Vehicle Speed signal invalid (36)
产生此代码的情况:
发动机控制模块 (ECM) 检测到以下情况:
- "VSL 保护"未编程设定在设定后的 "TEL" 上。
- 车速在发动机参数指示车速应变化时恒定。
- 发动机转速高于 950 rpm 超过 60 ms。
注: 该代码通常在有人干预车速信号后出现。
系统响应:
发动机转速限定在编程设定的 "VSL 保护"上一小时。 如果 ECM 提供转速表信号的话,则车辆行驶后发生故障时转速表可反映车速的缺失。
该故障诊断代码为激活状态时,卡特彼勒电子技师 (ET) 状态屏上"发动机转速"旁边将显示"诊断"。
驾驶员可能认为发动机功率偏低,并且发动机不能达到期望转速。 额定功率下降工况一直保持到不存在该故障后的一小时内。
测试步骤 1. 进行以下的诊断步骤: 车速和车速表电路 - 测试
结果:
- 正常 - 停止
Caterpillar Information System:
3126B and 3126E On-highway Engines 0084-01 Vehicle Speed loss of signal (31)
3408E and 3412E Industrial Engines Electronic Service Tools
3126B and 3126E On-highway Engines 0091-13 Throttle Position out of calibration (28)
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application 0030-13 PTO Throttle Sensor Calibration (29)
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application 0030-08 Invalid PTO Throttle Signal (29)
3054B Industrial Engine Piston Cooling Jets - Remove and Install
3126B Marine Engine Turbocharger - Install
3126B Marine Engine Turbocharger - Remove
3126B and 3126E On-highway Engines 0168-02 ECM Battery Power Intermittent (51)
3126B Marine Engine Water Pump - Assemble
3126B Engines for Caterpillar Built Machines Crankshaft Gear - Remove and Install
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Glossary
3126B and 3126E On-highway Engines 0084-08 Vehicle Speed signal out of range (36)
Uninterruptible Power Supply (UPS) 250 Time and Date Adjustment
3618 Engine Cylinder Liner - Install
3126B Marine Engine Auxiliary Water Pump - Disassemble
3126B and 3126E On-highway Engines 0084-10 Vehicle Speed signal rate of change (36)
3126B Marine Engine Exhaust Manifold - Remove and Install
3054B Industrial Engine Cylinder Head - Remove
Uninterruptible Power Supply (UPS) 250 Oil - Change
Uninterruptible Power Supply (UPS) 250 Display Contrast Adjustment
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Electronic Display Module - If Equipped
Uninterruptible Power Supply (UPS) 250 Oil Level - Check
Uninterruptible Power Supply (UPS) 250 Sight Gauge - Clean