Time and Date Adjustment
Show/hide table
Illustration 1 | g00665308 |
Display Monitor (1) Soft keys (2) Up arrow key (3) Down arrow key |
Once power is applied to the system, the display will be active. Adjust the clock to the correct time and the correct date.
- If "Menu" is not displayed above the soft key (1) to the far left, then press the soft key (1) under "Home".
- Press the soft key (1) under "Menu".
- Use the up arrow key (2) and the down arrow key (3) in order to highlight the "Settings" window.
- When this window is highlighted, press the soft key (1) under "Select".
- Use the up arrow key (2) and the down arrow key (3) in order to highlight the "Time and Date" window.
- When this window is highlighted, press the soft key (1) under "Select".
- Use the up arrow key (2) and the down arrow key (3) in order to increase or decrease the desired window.
- Press the soft key (1) under "Tab" in order to bypass any window that does not need adjusting.
- If you need to restore the original setting, press the soft key (1) under "Restore" before you press the soft key (1) under "Accept".
- Once the proper time and the proper date is adjusted, press the soft key (1) under "Accept".
Caterpillar Information System:
3126B and 3126E On-highway Engines 0084-08 Vehicle Speed signal out of range (36)
3126B and 3126E On-highway Engines 0084-02 Vehicle Speed signal invalid (36)
3126B and 3126E On-highway Engines 0084-01 Vehicle Speed loss of signal (31)
3408E and 3412E Industrial Engines Electronic Service Tools
3126B and 3126E On-highway Engines 0091-13 Throttle Position out of calibration (28)
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application 0030-13 PTO Throttle Sensor Calibration (29)
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application 0030-08 Invalid PTO Throttle Signal (29)
3054B Industrial Engine Piston Cooling Jets - Remove and Install
3126B Marine Engine Turbocharger - Install
3126B Marine Engine Turbocharger - Remove
3126B and 3126E On-highway Engines 0168-02 ECM Battery Power Intermittent (51)
3126B Marine Engine Water Pump - Assemble
3618 Engine Cylinder Liner - Install
3126B Marine Engine Auxiliary Water Pump - Disassemble
3126B and 3126E On-highway Engines 0084-10 Vehicle Speed signal rate of change (36)
3126B Marine Engine Exhaust Manifold - Remove and Install
3054B Industrial Engine Cylinder Head - Remove
Uninterruptible Power Supply (UPS) 250 Oil - Change
Uninterruptible Power Supply (UPS) 250 Display Contrast Adjustment
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Electronic Display Module - If Equipped
Uninterruptible Power Supply (UPS) 250 Oil Level - Check
Uninterruptible Power Supply (UPS) 250 Sight Gauge - Clean
Caterpillar Monitoring System for Electronic Modular Control Panel CID 0828 FMI 08 Temperature Sensor (Right Exhaust) Abnormal Signal - Test
Uninterruptible Power Supply (UPS) 250 Air Filter - Replace