Display Contrast Adjustment
Show/hide table
Illustration 1 | g00665308 |
Display Monitor (1) Soft keys (2) Up arrow key (3) Down arrow key |
Once the power is applied to the system, the display should be active. Adjust the contrast for the best viewing.
- If "Menu" is not displayed above the soft key (1) that is to the far left, then press the soft key (1) under "Home".
- Use the up arrow key (2) and the down arrow key (3) in order to increase or decrease the contrast of the screen.
- Once the screen is adjusted for the best viewing, the adjustment is done. The current setting is saved in non-volatile memory. The non-volatile memory will remember the setting through the power cycles.
Caterpillar Information System:
Uninterruptible Power Supply (UPS) 250 Oil - Change
3054B Industrial Engine Cylinder Head - Remove
3126B Marine Engine Exhaust Manifold - Remove and Install
3126B and 3126E On-highway Engines 0084-10 Vehicle Speed signal rate of change (36)
3126B Marine Engine Auxiliary Water Pump - Disassemble
3618 Engine Cylinder Liner - Install
Uninterruptible Power Supply (UPS) 250 Time and Date Adjustment
3126B and 3126E On-highway Engines 0084-08 Vehicle Speed signal out of range (36)
3126B and 3126E On-highway Engines 0084-02 Vehicle Speed signal invalid (36)
3126B and 3126E On-highway Engines 0084-01 Vehicle Speed loss of signal (31)
3408E and 3412E Industrial Engines Electronic Service Tools
3126B and 3126E On-highway Engines 0091-13 Throttle Position out of calibration (28)
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Electronic Display Module - If Equipped
Uninterruptible Power Supply (UPS) 250 Oil Level - Check
Uninterruptible Power Supply (UPS) 250 Sight Gauge - Clean
Caterpillar Monitoring System for Electronic Modular Control Panel CID 0828 FMI 08 Temperature Sensor (Right Exhaust) Abnormal Signal - Test
Uninterruptible Power Supply (UPS) 250 Air Filter - Replace
Caterpillar Monitoring System for Electronic Modular Control Panel CID 0460 FMI 08 Pressure Sensor (Fuel) Abnormal Signal - Test
Uninterruptible Power Supply (UPS) 250 Bearing - Replace
Uninterruptible Power Supply (UPS) 250 Flywheel - Clean
Uninterruptible Power Supply (UPS) 250 General Operation
Uninterruptible Power Supply (UPS) 250 Placing the System On-line
Caterpillar Monitoring System for Electronic Modular Control Panel Charging System - Test
3054B Industrial Engine Cylinder Head - Install