Turbocharger - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Apply 5P-3931 Anti-Seize Compound on the threads of the mounting studs for the turbocharger.
- Position the turbocharger gasket and turbocharger (10) on the exhaust manifold. Install nuts (9) and tighten nuts (9) to a torque of 54 ± 5 N·m (40 ± 4 lb ft).
Show/hide table
Illustration 1 | g00646117 |
- Install the hose and tighten hose clamp (8) .
Show/hide table
Illustration 2 | g00646114 |
- Put tube (7) in position on the turbocharger and install two bolts (6) .
- Install the tube and tighten fitting (5) .
- Lubricate O-ring seal (4) with 1U-6396 O-Ring Assembly Compound .
Show/hide table
Illustration 3 | g00646065 |
- Install elbow (3) and O-ring seal (4) on the turbocharger.
- Position the retaining plates and install two bolts (2) .
Show/hide table
Illustration 4 | g00646061 |
- Install the hose and tighten hose clamp (1) .
End By: Install the air cleaner. Refer to Disassembly and Assembly, "Air Cleaner - Remove and Install".
Caterpillar Information System:
3126B Marine Engine Turbocharger - Remove
3126B and 3126E On-highway Engines 0168-02 ECM Battery Power Intermittent (51)
3126B Marine Engine Water Pump - Assemble
3126B Engines for Caterpillar Built Machines Crankshaft Gear - Remove and Install
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Glossary
3512B Marine Auxiliary Engine Black Start Push Button
SR4 HV and SR4B HV Generators Rotating Rectifier - Check
SR4 HV and SR4B HV Generators Continuous Operation
3512B Marine Auxiliary Engine Low Idle/High Idle Switch
3054B Industrial Engine Fan Drive - Install
3126B Marine Engine Engine Oil Cooler - Install
3126B Marine Engine Engine Oil Cooler - Remove
3054B Industrial Engine Piston Cooling Jets - Remove and Install
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application 0030-08 Invalid PTO Throttle Signal (29)
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application 0030-13 PTO Throttle Sensor Calibration (29)
3126B and 3126E On-highway Engines 0091-13 Throttle Position out of calibration (28)
3408E and 3412E Industrial Engines Electronic Service Tools
3126B and 3126E On-highway Engines 0084-01 Vehicle Speed loss of signal (31)
3126B and 3126E On-highway Engines 0084-02 Vehicle Speed signal invalid (36)
3126B and 3126E On-highway Engines 0084-08 Vehicle Speed signal out of range (36)
Uninterruptible Power Supply (UPS) 250 Time and Date Adjustment
3618 Engine Cylinder Liner - Install
3126B Marine Engine Auxiliary Water Pump - Disassemble
3126B and 3126E On-highway Engines 0084-10 Vehicle Speed signal rate of change (36)