Fuel Filter Housing - Install
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Attach suitable straps and a lifting device to fuel filter (8). The fuel filter weighs approximately
50 kg (110 lb) . Lift the fuel filter into position on the engine. - Install bolts and washers (7) that attach the fuel filter to the engine.
Show/hide table
Illustration 2 g00635095 - Connect tube (6) that is behind the fuel priming pump.
Show/hide table
Illustration 3 g00635092 - Connect hose (4) and tube (5).
Show/hide table
Illustration 4 g00635079 - Connect two electrical connectors (3).
Show/hide table
Illustration 5 g00635075 - Install new seals for the joints between flanges (1) and the expansion tank and the water temperature regulator housing.
- Install four flanges (1) and two tubes (2) between the expansion tank and the water temperature regulator housing. Install the bolts and washers for the flanges.
- Fill the cooling system. For the correct coolant to use, see the Operation and Maintenance Manual.
- Prime the fuel system. For instructions, see the Operation and Maintenance Manual.
Show/hide table
| |
| Illustration 1 | g00635098 |
|
Typical illustration | |
Caterpillar Information System:
3512B Marine Auxiliary Engines Fuel Filter Housing - Remove
3512B Marine Auxiliary Engines Electronic Control Module (Engine) - Remove and Install
C-9 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
C-18 Truck Engines Customer Specified Parameters
C9 Engine For Caterpillar Built Machines Lifter Group - Remove and Install
3512B Marine Auxiliary Engines Jacket Water Heater - Remove and Install
3512B Marine Auxiliary Engines Prelubrication Oil Pump - Remove and Install
C9 Engine For Caterpillar Built Machines Cylinder Head - Install
69D, 769D, 773D, 773E, 776D and 777D Off-Highway Trucks and 771D, 775D and 775E Quarry Trucks Power Train Electronic Control System Electrical Connector - Inspect
3512B Marine Auxiliary Engines Barring Group - Remove and Install
C9 Engine For Caterpillar Built Machines Cylinder Head - Remove
SR4 and SR4B Electric Power Generation Rewind Data General Information
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove - 3013, 3014 and 3024 Engines
3054, 3054B and 3056 Marine Engines Engine Oil Pump
C-15, C-16, and C-18 Engines Electronic Control System Components
3512B Marine Auxiliary Engines Turbocharger - Remove
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Rocker Shaft - Disassemble - 3013, 3014 and 3024 Engines
3056E Industrial Engine Engine Oil Bypass Valve
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Rocker Shaft - Assemble - 3013, 3014, and 3024 Engines
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
C-9 Engines for Caterpillar Built Machines Engine Oil Pressure - Test
3003, 3013, 3014 and 3024 Industrial Engines Fuel System Primary Filter/Water Separator - Drain
3056 Engine for Caterpillar Built Machines Connecting Rod Bearings - Remove
3512B Marine Auxiliary Engines Turbocharger - Install