Barring Group - Remove and Install
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Turn OFF the pressurized air supply to barring motor (1). Purge the pressurized air from the air lines and from the barring motor.
- Mark the hoses that are attached to barring motor (1) and mark the fittings for the hoses on the barring motor for identification upon installation. Disconnect the hoses from the barring motor.
- Remove three bolts (2) that attach barring motor (1) to the flywheel housing. Remove the barring motor.
- Remove the gasket from the joint between barring motor (1) and the flywheel housing. Discard the gasket.
Show/hide table
| |
| Illustration 1 | g00634764 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new gasket for the joint between barring motor (1) and the flywheel housing.
- Place barring motor (1) into position on the flywheel housing. Install three bolts (2) that attach the barring motor to the flywheel housing.
- Use the identification marks on the hoses and on the fittings of barring motor (1). Connect the hoses to the barring motor.
Show/hide table
|
| |
| Illustration 2 | g00634764 |
Caterpillar Information System:
C9 Engine For Caterpillar Built Machines Cylinder Head - Remove
SR4 and SR4B Electric Power Generation Rewind Data General Information
C-9 Engines for Caterpillar Built Machines Aftercooler - Test
3054 and 3056 Industrial and Generator Set Engines Turbocharger
3003, 3013, 3014 and 3024 Industrial Engines Starting the Engine
C9 Engines for Caterpillar Built Machines Crankshaft - Install
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0276 - FMI 13 Left Turbo Inlet Pressure calibration required
3054E and 3056E Industrial Engines Engine Starting
C-9 Engines for Caterpillar Built Machines Inlet Manifold Pressure - Test
C9 Engines for Caterpillar Built Machines Crankshaft - Remove
3176C and 3196 Industrial Engines Air Compressor Drive Gear - Install
3612 and 3616 Engines Vibration Damper - Install
69D, 769D, 773D, 773E, 776D and 777D Off-Highway Trucks and 771D, 775D and 775E Quarry Trucks Power Train Electronic Control System Electrical Connector - Inspect
C9 Engine For Caterpillar Built Machines Cylinder Head - Install
3512B Marine Auxiliary Engines Prelubrication Oil Pump - Remove and Install
3512B Marine Auxiliary Engines Jacket Water Heater - Remove and Install
C9 Engine For Caterpillar Built Machines Lifter Group - Remove and Install
C-18 Truck Engines Customer Specified Parameters
C-9 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
3512B Marine Auxiliary Engines Electronic Control Module (Engine) - Remove and Install
3512B Marine Auxiliary Engines Fuel Filter Housing - Remove
3512B Marine Auxiliary Engines Fuel Filter Housing - Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove - 3013, 3014 and 3024 Engines
3054, 3054B and 3056 Marine Engines Engine Oil Pump