Rocker Shaft - Assemble - 3013, 3014, and 3024 Engines
Assembly Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Lubricate all of the components with clean engine oil.
- Position rocker shaft (5) in the end of base (7) .
Show/hide table
Illustration 1 | g00599882 |
Typical example (1) Rocker arm (2) Rocker arm (3) Washer (4) Spring (5) Rocker shaft (6) O-ring seal (7) Base |
- Gradually insert rocker shaft (5) and install rocker arm (1) .
- Insert rocker shaft (5) and install rocker arm (2) .
- Slide rocker shaft (5) through washer (3) and spring (4) .
- Repeat Steps 3 through 5 in order to install the remaining components.
End By: Install the rocker shaft and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Install".
Caterpillar Information System:
3056E Industrial Engine Engine Oil Bypass Valve
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Rocker Shaft - Disassemble - 3013, 3014 and 3024 Engines
3512B Marine Auxiliary Engines Turbocharger - Remove
C-15, C-16, and C-18 Engines Electronic Control System Components
3054, 3054B and 3056 Marine Engines Engine Oil Pump
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove - 3013, 3014 and 3024 Engines
3512B Marine Auxiliary Engines Fuel Filter Housing - Install
3512B Marine Auxiliary Engines Fuel Filter Housing - Remove
3512B Marine Auxiliary Engines Electronic Control Module (Engine) - Remove and Install
C-9 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
C-18 Truck Engines Customer Specified Parameters
C9 Engine For Caterpillar Built Machines Lifter Group - Remove and Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
C-9 Engines for Caterpillar Built Machines Engine Oil Pressure - Test
3003, 3013, 3014 and 3024 Industrial Engines Fuel System Primary Filter/Water Separator - Drain
3056 Engine for Caterpillar Built Machines Connecting Rod Bearings - Remove
3512B Marine Auxiliary Engines Turbocharger - Install
C-15, C-16, and C-18 Truck Engines Engine Design
C-15, C-16, and C-18 Truck Engines Valve Mechanism Cover
3406E Truck Engine Compression Brake - If Equipped
3003, 3013, 3014 and 3024 Industrial Engines Fuel System - Prime
3406E Truck Engine Engine Oil Pan
C-15, C-16, and C-18 Truck Engines Cylinder Block
SR4 and SR4B Electric Power Generation Rewind Data Generator Identification