Engine Oil Pan
Show/hide table
Illustration 1 | g00448568 |
(1) Tighten the drain plug to the following torque. ... 25 ± 5 N·m (18 ± 4 lb ft)
Apply 1U-8846 Liquid Gasket to four areas on the sealing surface of the oil pan. The areas are marked location (Y). The areas are at the corners of the oil pan in the following locations:
- connecting joint of the front housing and the front of the cylinder block
- connecting joint of the flywheel housing and the rear of the cylinder block
Use the following procedure in order to tighten the bolts for the oil pan.
Tighten four bolts (X) .
Start with bolt (Z) and tighten all remaining bolts in a counterclockwise sequence.
Tighten the bolts to the following torque. ... 31 ± 3 N·m (23 ± 2 lb ft)
Start again with bolt (Z) and tighten all remaining bolts in a counterclockwise sequence.
Tighten the bolts to the following torque. ... 31 ± 3 N·m (23 ± 2 lb ft)
Caterpillar Information System:
C15 Petroleum Generator Set Engines Cooling System - Test
G3612 and G3616 Engines Engine Oil Coolers - Install
G3612 and G3616 Engines Engine Oil Coolers - Remove
G3612 and G3616 Engines Engine Oil Coolers - Assemble
3114, 3116 and 3126 Engines Fuel Quality
3612 and 3616 Engines Engine Oil Coolers - Disassemble
3406E and 3456 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
C15 and C18 Petroleum Generator Sets Engine Operation with Active Diagnostic Codes
3612 and 3616 Engines Engine Oil Coolers - Install
3406E and 3456 Engines for Caterpillar Built Machines Aftercooler - Test
3612 and 3616 Engines Engine Oil Coolers - Remove
C15 Petroleum Generator Set Engines Finding Top Center Position for No. 1 Piston
SR500 Generators Generator Start-up Checklist
G3612 and G3616 Engines Engine Oil Filter Housings - Remove
3406E and 3456 Engines for Caterpillar Built Machines Water Pump - Test
3612 and 3616 Engines Aftercooler - Remove - Standard Aftercooler
Generator Set Load Sensor Engine Will Not Operate in Parallel - Troubleshoot
3408E and 3412E Engines for Caterpillar Built Machines Connecting Rod Bearings - Inspect
3408E and 3412E Engines for Caterpillar Built Machines Main Bearings - Inspect
Generator Set Load Sensor Undesired Speed Decrease with Load Increase - Troubleshoot
Generator Set Load Sensor Erratic Operation of Load Sensor - Troubleshoot
G3612 and G3616 Engines Engine Oil Filter Housings - Install
3612 and 3616 Engines Aftercooler - Install - High Performance Aftercooler
3126B Truck Engine General Information