Engine Oil Coolers - Install
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 将适当的起吊设备连接在发动机机油冷却器 (6) 上。 发动机机油冷却器 (6) 的重量约为
263 kg (580 lb) 。 在发动机油滤清器上将发动机油冷却器 (6)放置到位。 安装固定发动机油冷却器 (6)入位的螺栓。 - 将一个新的 O 形密封圈安装到法兰中,并将管路 (10)连接到机油冷却器底盖。
- 安装管 (8)。
- 安装管 (5)。 安装弯头 (9)。
- 如果配备,将卡箍 (7)放置到位。 安装将卡箍 (7)固定入位的螺栓。
Show/hide table
图 2 g00608527 - 安装管 (2) 和 (3)。
- 安装管组件 (4)。 安装管组件 (1)。
- 将发动机油温传感器的线束组件连接到发动机油冷却器。
- 向发动机加注机油到正确的油位。 请参阅操作和保养手册, "发动机机油 - 更换"。
- 向冷却系统加注冷却液。 请参阅操作和保养手册, "冷却系统冷却液(ELC)- 更换"。
Show/hide table
图 1 | g01292754 |
Caterpillar Information System:
3406E and 3456 Engines for Caterpillar Built Machines Aftercooler - Test
3612 and 3616 Engines Engine Oil Coolers - Remove
C15 Petroleum Generator Set Engines Finding Top Center Position for No. 1 Piston
G3612 and G3616 Engines Engine Oil Pump - Assemble
G3612 and G3616 Engines Engine Oil Pump - Disassemble
3612 and 3616 Engines Engine Oil Pump - Install
C15 Petroleum Generator Set Engines Gear Group (Front) - Time
C27 and C32 Engines Electronic Unit Injector - Test
3512 and 3516 EUI Engines for 784B, 785B, 789B and 793B Off-Highway Trucks Engine Overspeeds on Start-up
C15 and C18 Petroleum Generator Sets Diagnostic Lamp
3408E and 3412E Engines for Caterpillar Built Machines Fuel System Pressure - Test
Generator Set Load Sensor Engine Does Not Share Load - Troubleshoot
C15 and C18 Petroleum Generator Sets Engine Operation with Active Diagnostic Codes
3406E and 3456 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
3612 and 3616 Engines Engine Oil Coolers - Disassemble
3114, 3116 and 3126 Engines Fuel Quality
G3612 and G3616 Engines Engine Oil Coolers - Assemble
G3612 and G3616 Engines Engine Oil Coolers - Remove
G3612 and G3616 Engines Engine Oil Coolers - Install
C15 Petroleum Generator Set Engines Cooling System - Test
3126B Truck Engine Engine Oil Pan
SR500 Generators Generator Start-up Checklist
G3612 and G3616 Engines Engine Oil Filter Housings - Remove
3406E and 3456 Engines for Caterpillar Built Machines Water Pump - Test