Engine Oil Pump - Disassemble
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件说明 | 数量 |
A | 1H-3107 | 轴承拉拔器 | 1 |
开始:
- 拆卸机油泵。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 彻底清洁机油泵的外部。 在清洁区域拆解机油泵。
Show/hide table
图 1 g00550544 - 从机油泵后部卸下盖 ( 1) 和盖 (2)。
- 将机油泵放置在合适位置。 齿轮应朝上。
Show/hide table
图 2 g00550545 - 拧松齿轮 (5) 上的螺栓 ( 4),直到垫圈 (3) 和齿轮之间的距离为
3.20 mm (0.126 inch) 。 - 使用两个 0S-1619 螺栓 和垫圈安装工具 ( A)。 拧紧工具 (A)中的螺钉。 敲打机油泵轴上的工具 ( A),使轴上的齿轮松动。 拆下工具 (A) 和齿轮 ( 5)。
Show/hide table
图 3 g00550546 - 卸下盖 (6)。 注意护盖中定位销的位置。 如有必要,拆下定位销。
Show/hide table
图 4 g00550614 注: 图中的轴承有一个内槽。 发动机机油泵的新轴承不带有一个内部凹槽。
- 如有必要,从盖 ( 6) 上卸下轴承 (7)。 如有必要,从盖 (6) 的另一侧卸下销。
Show/hide table
图 5 g00550615 - 从泵 (9) 的泵体上卸下机油泵传动轴 ( 8)。
- 从泵 (9) 的泵体上卸下机油泵惰轮轴 ( 10)。
- 如有必要,从泵 ( 9) 的泵体上中卸下轴承。
Caterpillar Information System:
3612 and 3616 Engines Engine Oil Pump - Install
C15 Petroleum Generator Set Engines Gear Group (Front) - Time
C27 and C32 Engines Electronic Unit Injector - Test
3512 and 3516 EUI Engines for 784B, 785B, 789B and 793B Off-Highway Trucks Engine Overspeeds on Start-up
C15 and C18 Petroleum Generator Sets Diagnostic Lamp
3408E and 3412E Engines for Caterpillar Built Machines Fuel System Pressure - Test
Generator Set Load Sensor Engine Does Not Share Load - Troubleshoot
3500B Locomotive Engines Start/Run/Stop Switch
3176B Marine Engine Cold Weather Starting
3114, 3116 and 3126 Engines Fuel Transfer Pump
3034 Engine for Caterpillar Built Machines Engine Oil Pressure
3500B Locomotive Engines Injector Solenoids
G3612 and G3616 Engines Engine Oil Pump - Assemble
C15 Petroleum Generator Set Engines Finding Top Center Position for No. 1 Piston
3612 and 3616 Engines Engine Oil Coolers - Remove
3406E and 3456 Engines for Caterpillar Built Machines Aftercooler - Test
3612 and 3616 Engines Engine Oil Coolers - Install
C15 and C18 Petroleum Generator Sets Engine Operation with Active Diagnostic Codes
3406E and 3456 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
3612 and 3616 Engines Engine Oil Coolers - Disassemble
3114, 3116 and 3126 Engines Fuel Quality
G3612 and G3616 Engines Engine Oil Coolers - Assemble
G3612 and G3616 Engines Engine Oil Coolers - Remove
G3612 and G3616 Engines Engine Oil Coolers - Install