Engine Oil Coolers - Assemble
Show/hide table
注意 |
---|
在检查、保养、测试、调整及维修产品时,请小心确保盛接油液。 在打开任何舱室或拆卸任何含有油液的部件前,请准备好盛接液体用的适当容器。 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 将起重机固定至机油冷却器芯 ( 14)。 将芯放置在支架组件 ( 12) 上的合适位置。 从芯的端部至支架组件 ( X) 上第一个螺栓孔中心线的距离必须为
436 ± 1 mm (17.16 ± 0.04 inch) 。 - 将垫片和机罩 (9) 安装在机油冷却器芯 ( 14) 的两端。
- 安装支架 (11),以便将机油冷却器芯固定到位。
- 将机油温度调节器壳体 ( 13) 安装在支架 (11) 上。
注: 较新的发动机配备具有更长出口的机油温度调节器 ( 13)。
- 将法兰 (3) 和管 ( 5) 安装在机油温度调节器壳体的两侧。
- 安装歧管 (6)。 安装另一根歧管 (10)。
- 将弯头 (8)安装在歧管 ( 6) 上。
- 将起重机固定至机油冷却器芯 ( 4)上。 将芯安装在歧管 ( 6)和另一根歧管 (10) 上。
- 将以下部件安装在机油冷却器的两端: 机罩 (2) , 管 (7) 和 弯头 ( 1)。
- 安装机油冷却器。
Show/hide table
图 1 | g00608601 |
此图为典型的安装图示。 |
Show/hide table
图 2 | g00608623 |
Caterpillar Information System:
3114, 3116 and 3126 Engines Fuel Quality
3612 and 3616 Engines Engine Oil Coolers - Disassemble
3406E and 3456 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
C15 and C18 Petroleum Generator Sets Engine Operation with Active Diagnostic Codes
3612 and 3616 Engines Engine Oil Coolers - Install
3406E and 3456 Engines for Caterpillar Built Machines Aftercooler - Test
3612 and 3616 Engines Engine Oil Coolers - Remove
C15 Petroleum Generator Set Engines Finding Top Center Position for No. 1 Piston
G3612 and G3616 Engines Engine Oil Pump - Assemble
G3612 and G3616 Engines Engine Oil Pump - Disassemble
3612 and 3616 Engines Engine Oil Pump - Install
C15 Petroleum Generator Set Engines Gear Group (Front) - Time
G3612 and G3616 Engines Engine Oil Coolers - Remove
G3612 and G3616 Engines Engine Oil Coolers - Install
C15 Petroleum Generator Set Engines Cooling System - Test
3126B Truck Engine Engine Oil Pan
SR500 Generators Generator Start-up Checklist
G3612 and G3616 Engines Engine Oil Filter Housings - Remove
3406E and 3456 Engines for Caterpillar Built Machines Water Pump - Test
3612 and 3616 Engines Aftercooler - Remove - Standard Aftercooler
Generator Set Load Sensor Engine Will Not Operate in Parallel - Troubleshoot
3408E and 3412E Engines for Caterpillar Built Machines Connecting Rod Bearings - Inspect
3408E and 3412E Engines for Caterpillar Built Machines Main Bearings - Inspect
Generator Set Load Sensor Undesired Speed Decrease with Load Increase - Troubleshoot