Undesired Speed Decrease with Load Increase - Troubleshoot
- Install a jumper between terminals 13 and 14 of the load sensing module.
- Operate the engine. Apply the load.
Expected Result: The problem has been corrected.
Results:
- OK: Repair the wiring or the switch. STOP.
- NOT OK: Go to 2.
- OK: Repair the wiring or the switch. STOP.
- Check engine operation.
- Operate the engine.
- Observe speed while you are applying the load.
Expected Result: Droop occurs near the full load point only.
Results:
- OK: It is possible that the engine is not producing the horsepower. It is also possible that the engine is being overloaded. Verify that the engine is within the load limits. Refer to the engine Service Manual, Service Procedures, "Engine Performance Check".
- NOT OK: Go to 3.
- OK: It is possible that the engine is not producing the horsepower. It is also possible that the engine is being overloaded. Verify that the engine is within the load limits. Refer to the engine Service Manual, Service Procedures, "Engine Performance Check".
- Check for faulty engine control.
- Disconnect the load sensing module.
- Load the engine as a single isolated unit.
Expected Result: The problem has been resolved.
Results:
- OK: Check the load sensor for defects. STOP.
- NOT OK: The speed continues to decrease with load. Check the engine governor. STOP.
- OK: Check the load sensor for defects. STOP.
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Main Bearings - Inspect
3408E and 3412E Engines for Caterpillar Built Machines Connecting Rod Bearings - Inspect
Generator Set Load Sensor Engine Will Not Operate in Parallel - Troubleshoot
3612 and 3616 Engines Aftercooler - Remove - Standard Aftercooler
3406E and 3456 Engines for Caterpillar Built Machines Water Pump - Test
G3612 and G3616 Engines Engine Oil Filter Housings - Remove
SR500 Generators Generator Start-up Checklist
3126B Truck Engine Engine Oil Pan
C15 Petroleum Generator Set Engines Cooling System - Test
G3612 and G3616 Engines Engine Oil Coolers - Install
G3612 and G3616 Engines Engine Oil Coolers - Remove
G3612 and G3616 Engines Engine Oil Coolers - Assemble
Generator Set Load Sensor Erratic Operation of Load Sensor - Troubleshoot
G3612 and G3616 Engines Engine Oil Filter Housings - Install
3612 and 3616 Engines Aftercooler - Install - High Performance Aftercooler
3126B Truck Engine General Information
3126B Truck Engine Glossary of Electronic Control Terms
C15 Petroleum Generator Set Engines Cylinder Liner Projection - Inspect
3114, 3116 and 3126 Engines Unit Injector Cranking Rack Position
C15 Petroleum Generator Set Engines Flywheel - Inspect
G3612 and G3616 Engines Engine Oil Filter Housings - Disassemble
C15 Petroleum Generator Set Engines Piston Ring Groove - Inspect
G3612 and G3616 Engines Engine Oil Filter Housings - Assemble
3406E Generator Set Engines Annunciator Panel - Inspect