Center Axle - Remove and Install
拆卸步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件说明     | 数量     |
A     | 9U-7546     | 插孔     | 2     |
4C-5809 | 电动液压泵总成     | 1     | |
B     | 236-1192     | 提升油缸支撑组件     | 3     |
C     | 1U-7505     | 液压千斤顶     | 1     |
D     | 138-7574     | 连杆支架     | 2     |
开始:
- 拆下转速传感器(牵引力控制)
- 拆下中间轮轴的稳定器杆。
- 拆下中间驱动轴。
- 拆下后驱动轴。
Show/hide table
高压油能使人受伤。 不要让高压油碰到皮肤。 对高压油系统进行作业时, 要穿戴适合的防护衣物。 |
Show/hide table
带载的传动系拧紧扭矩可造成人身伤害。 不等的车轮转速可产生传动系拧紧扭矩,从而使传动系部件在拆解中带载。 拆解前,务必释放传动系拧紧扭矩。 |
Show/hide table
吊装或垫塞不当可能会造成人员伤亡。 当使用起重机或千斤顶顶升任何零件或部件时,与之保持距离。 确保起重机或千斤顶具备正确的部件吊装能力。 在沉重部件下面进行任何工作之前先安装垫块或台架。 图上显示的是部件的近似重量。 清洁要安装零件的所有表面。 |
- 将实心钢块 (1) 放到机器两侧的平衡臂 (2) 后面和悬架挡块之间。 采用长度为 102 mm (4.00 in) 的 50.80 mm (2.00 in) 钢块。
Show/hide table
图 1 | g01192964 |
- 将工具 (A) 安装到后桥下方。 利用工具 (A) 升起机器后部。
Show/hide table
图 2 | g01192912 |
- 断开软管组件 (3) 和 (4) 。 将驱动轴 (5) 从中轴的后部断开。
Show/hide table
图 3 | g01192920 |
- 将驱动轴 (6) 从中轴的前部断开。 断开软管组件 (7) 、 (8) 、 (9) 、 (10) 、 (11) 和 (12) 。
Show/hide table
图 4 | g01192924 |
- 拆下螺栓 (13) 和 (14) 。 拆下挡板 (15) 。 对另一侧重复上述步骤。
Show/hide table
图 5 | g01192987 |
- 拆下中轴的轮胎和轮缘。 采用以下程序拆下中轴的轮胎和轮缘。
- 升起卡车车斗。 利用工具 (B) 将卡车车斗固定到升起位置。 由两人定位工具 (B) 。 工具 (B) 的重量约为 37 kg (80 lb)。
Show/hide table图 6 g01193059
- 将适当的起吊设备固定到中轴的轮胎和轮缘 (16) 上。 轮胎和轮缘 (16) 的重量约为 862 kg (1900 lb)。 拆下带耳螺母 (17) 后拆下轮胎和轮缘 (16) 。
Show/hide table图 7 g01208418
- 将工具 (C) 放到悬架 (22) 的下方。 断开润滑脂软管组件 (18) 。 拆下螺栓 (19) 、螺母 (20) 和垫圈 (21) 。
Show/hide table
图 8 | g01193138 |
- 拆下销 (23) 。
Show/hide table
图 9 | g01193359 |
- 将工具 (D) 和适当的起吊设备固定到中轴组件 (24) 的每侧上。 中轴组件 (24) 的重量约为 2487 kg (5485 lb)。
Show/hide table
图 10 | g01193024 |
- 拆下螺栓 (26) ,以便将安装件组件 (25) 从中轴组件 (24) 上断开。
Show/hide table
图 11 | g01193305 |
- 利用适当的起吊设备和工具 (C) 将中轴组件 (24) 和悬架 (22) 作为一体降至地面上。
Show/hide table
图 12 | g01193024 |
Show/hide table
图 13 | g01193311 |
安装步骤
- 按与拆卸相反的顺序安装中间悬架框架 (1) 。
- 拧紧螺栓 (19) 和螺母 (18) 至扭矩为 800 ± 100 N·m (590 ± 75 lb ft)。
- 拧紧螺栓 (21) 至扭矩为 460 ± 60 N·m (340 ± 45 lb ft)。
Caterpillar Information System:
C13, C15, and C18 Tier 4 Final Engines Vibration Damper
735B, 740B and 740B EJECTOR Articulated Trucks Power Train Front Axle - Remove and Install
735B, 740B and 740B EJECTOR Articulated Trucks Power Train Axle Shaft - Remove and Install
C175-16 Locomotive Engine Valve Mechanism
C27 and C32 Engines for Caterpillar Built Machines Cylinder Block
2011/07/28 Correction to Disassembly and Assembly , "Final Drive and Brake - Install" for R2900G Load Haul Dump Machines {4050, 4251}
2470C, 2570C and 2670C Wheel Feller Bunchers Machine Systems Steering Cylinder - Remove and Install
2011/06/08 New Software Containing Engine Idle Shutdown Feature (EIS) Is Now Used on Certain Off-Highway Trucks {1920, 7620}
AP1000E and BG1000E Asphalt Pavers Machine Systems Relief Valve (Screed Counterbalance) - Test and Adjust
735B, 740B and 740B EJECTOR Articulated Trucks Power Train Rear Drive Shaft - Remove and Install
AP1000E and BG1000E Asphalt Pavers Machine Systems Pressure Reducing Valve - Test and Adjust - Shift Solenoid
AP1000E and BG1000E Asphalt Pavers Machine Systems Pump Control Valve (Auxiliary) - Test and Adjust
3516B Engine for 994F and 994H Wheel Loaders Throttle Lock - Test
541 Series 2 Track Feller Buncher and 552 Series 2 Track Feller Buncher Machine Systems Travel System
992K Wheel Loader Object Detection Sensor - Clean/Inspect
541 Series 2 Track Feller Buncher and 552 Series 2 Track Feller Buncher Machine Systems Control Valve (Travel)
2011/07/08 A New Pump Control Valve Group is Now Used on the Piston Pump Groups on Certain Off-Highway Trucks {5070}
2013/09/12 A New Aftercooler Core Assembly is Now Used in the Air Aftercooler Group on the 773F and 775F Off-Highway Trucks {1063, 1353, 1806}
C13, C15, and C18 Tier 4 Final Engines Engine Oil Pan
C27 Generator Set Fuel System Primary Filter (Water Separator) Element - Replace
541 Series 2 Track Feller Buncher and 552 Series 2 Track Feller Buncher Machine Systems Leveling System
C3.4B Industrial Engine Fan Clearance - Check
2011/06/02 A New Direction and Speed Control Gp is now Available for Certain Vibratory Asphalt Compactors {5462}
AP1000E and BG1000E Asphalt Pavers Machine Systems Fan Speed (Ventilation) - Test