| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | 138-7575 | Link Bracket | 2 |
Start By:
- Install the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chock (Front and Rear) - Remove and Install".
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
 |
|
At operating temperature, the hydraulic tank is hot and under pressure. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly in order to relieve pressure. |
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Note: Put identification marks on all hose assemblies, on all tube assemblies and on all wire harnesses for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss and this helps to prevent contaminants from entering the system.
- Drain the hydraulic tank into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Hoist, Torque Converter and Brake Tank Oil - Change".
- Drain the oil filter into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Transmission Oil Filter - Replace".
Show/hide table
Illustration 1 g01626492 - Remove bolts (1). Disconnect harness assembly (2).
Show/hide table
Illustration 2 g01626494 - Attach Tooling (A) onto oil filter and base (3). The weight of oil filter and base (3) is approximately
32 kg (70 lb) .Show/hide table
Illustration 3 g01626508 - Disconnect tube assembly (4). Disconnect elbow (5).
Show/hide table
Illustration 4 g01626509 - Remove bolts (6) in order to remove oil filter and base (3).
