| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | FT-1114 | Vacuum Cap | 1 |
Start By:
- Install the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chock (Front and Rear) - Remove and Install".
- Release the pressure from the hydraulic system. Refer to Disassembly and Assembly, "System Pressure - Release".
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
 |
|
At operating temperature, the hydraulic tank is hot and under pressure. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly in order to relieve pressure. |
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Put identification marks on all hose assemblies, on all tube assemblies and on all wire harnesses for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss and this helps to prevent contaminants from entering the system.
- Attach Tooling (A) onto the hydraulic tank. Attach an air supply hose onto Tooling (A). Apply
276 to 414 kPa (40 to 60 psi) . This procedure will pull vacuum on the hydraulic system.Show/hide table
Illustration 2 g01626563 - Disconnect harness assembly (1). Remove drain plug (2) in order to drain filter housing (3).
- Install drain plug (2).
- If necessary, remove filter housing (3).
Show/hide table
Illustration 3 g01626565 - Disconnect tube assembly (4) and tube assembly (5).
Show/hide table
Illustration 4 g01626567 - Remove bolts (6) in order to remove oil filter and base (7).
| |
| Illustration 1 | g01606514 |
