Valve Covers
Usage:
Remove And Install Valve Covers
1. Remove bolts (1) and valve cover (2).
2. Remove the seal from valve cover (2).
NOTE: The following steps are for the installation of the valve cover.
3. Make sure the seal is installed in the groove of valve cover (2).
4. Put valve cover (2) in position on the valve cover base and install bolts (1).
Caterpillar Information System:
3500 GENERATOR SET ENGINES Oil Sequence Valves
3500 GENERATOR SET ENGINES Flywheel Housing
3500 GENERATOR SET ENGINES Crankshaft Rear Seal And Wear Sleeve
3500 GENERATOR SET ENGINES Flywheel
3500 GENERATOR SET ENGINES Front Drive Housing
3500 GENERATOR SET ENGINES Crankshaft Front Seal And Wear Sleeve
3500 GENERATOR SET ENGINES Crankshaft Vibration Damper
3500 GENERATOR SET ENGINES Oil And Water Pump Drive
3500 GENERATOR SET ENGINES Accessory Drive (Front)
3500 GENERATOR SET ENGINES Governor Fastener Group
3500 GENERATOR SET ENGINES Governor Actuator Drive
3500 GENERATOR SET ENGINES Governor Actuator
3500 GENERATOR SET ENGINES Rocker Shaft Assemblies And Push Rods
3500 GENERATOR SET ENGINES Rocker Shaft Assemblies
3500 GENERATOR SET ENGINES Fuel Injectors
3500 GENERATOR SET ENGINES Fuel Injection Control Linkage
3500 GENERATOR SET ENGINES Cylinder Head Assemblies
3500 GENERATOR SET ENGINES Spacer Plates
3500 GENERATOR SET ENGINES Valves
3500 GENERATOR SET ENGINES Valve Lifters
3500 GENERATOR SET ENGINES Bridge Dowels
3500 GENERATOR SET ENGINES Valve Seat Inserts
3500 GENERATOR SET ENGINES Valve Guides
3500 GENERATOR SET ENGINES Piston Cooling Jets