Governor Actuator Drive
Usage:
Remove And Install Governor Actuator Drive
Start By:
a. remove governor actuator
1. Remove coupling (1) from the accessory drive shaft.
2. Remove the bolts and governor actuator drive housing (2).
3. Remove O-ring seals (3) and (4).
NOTE: The following steps are for the installation of the governor actuator drive.
4. Put clean engine oil on O-ring seals (3) and (4) and install them on governor actuator drive housing (2).
5. Install governor actuator drive housing (2) and the bolts.
6. Install coupling (1) in the end of the accessory drive shaft.
End By:
a. install governor actuator
Caterpillar Information System:
3500 GENERATOR SET ENGINES Governor Actuator
3500 GENERATOR SET ENGINES Exhaust Manifold
3500 GENERATOR SET ENGINES Air Inlet Manifold
3500 GENERATOR SET ENGINES Aftercooler
3500 GENERATOR SET ENGINES Exhaust Elbow
3500 GENERATOR SET ENGINES Turbochargers
3500 GENERATOR SET ENGINES Oil Cooler
3500 GENERATOR SET ENGINES Oil Pan
3500 GENERATOR SET ENGINES Oil Filter Base
3500 GENERATOR SET ENGINES Oil Pump
3500 GENERATOR SET ENGINES Fuel Transfer Pump
3500 GENERATOR SET ENGINES Fuel Filter Base
3500 GENERATOR SET ENGINES Governor Fastener Group
3500 GENERATOR SET ENGINES Accessory Drive (Front)
3500 GENERATOR SET ENGINES Oil And Water Pump Drive
3500 GENERATOR SET ENGINES Crankshaft Vibration Damper
3500 GENERATOR SET ENGINES Crankshaft Front Seal And Wear Sleeve
3500 GENERATOR SET ENGINES Front Drive Housing
3500 GENERATOR SET ENGINES Flywheel
3500 GENERATOR SET ENGINES Crankshaft Rear Seal And Wear Sleeve
3500 GENERATOR SET ENGINES Flywheel Housing
3500 GENERATOR SET ENGINES Oil Sequence Valves
3500 GENERATOR SET ENGINES Valve Covers
3500 GENERATOR SET ENGINES Rocker Shaft Assemblies And Push Rods